JVC HR-S4800U manual Edit To Or From Another, 46 EN, Load cassettes, Select edit mode

46 EN EDITING (cont.)

Edit To Or

From Another

VCR

2	Load cassettes
	Insert the playback cassette into the playback
	VCR and the cassette to be recorded on into the
	recording VCR.

3	Select input mode on recording VCR
	Select the correct external input on the other

VCR.

Connection
Ex. When using this VCR as the playback VCR
This VCR (for playback)
			REMOTE
			PAUSE/ IN OUT ANTENNA IN
		CABLE	AV
			COMPU
		BOX	-LINK
	IN	OUT	AUDIO
S			VHF/UHF
V			TV OUT
I			VIDEO
D			CH3 CH4
E
O
To S VIDEO			To AUDIO/
OUT			VIDEO OUT
S-video cable			Audio/video
(supplied)
			cable (supplied)
To S-video			4
			To Audio/
Input			video Input
			5
Another VCR (for recording)

c On this VCR (when using this VCR as the recording VCR);

Select “L-1” — when connecting the other VCR to the audio/video input connectors on the rear panel;

Select “F-1” — when connecting the other VCR to the audio/video input connectors on the front panel.

On the front panel:

Press CH5°.

On the Remote:

Press the Number key "0 (AUX)" or CH +/Ð.

NOTE:

When using this VCR as the recording VCR, set the video input terminal setting correctly (Z pg. 38 and 42).

Select edit mode

Set the edit mode to “ON” for the VCRs if such a mode is equipped.

c On this VCR, set “PICTURE CONTROL” to “EDIT” by following the procedure described on pages 38 and 39.

Start playback

Press PLAY ( 3 ) on the playback VCR.

NOTE:

You can use your VCR as the playback or recording VCR. c Refer also to the other VCR’s instruction manual for

connection and its operations.

1	Make connections
	Connect an audio/video cable between the

playback VCR’s audio/video output connectors and the recording VCR’s audio/video input connectors.

c When using this VCR as the recording VCR, connect this VCR’s audio/video input connectors to the audio/video output connectors on the other VCR.

If the playback VCR is monaural, connect the audio output connector on the playback VCR to the left audio input connector on this VCR.

		If the playback VCR is equipped with a superimpose/
	OSD disable feature then set it to “OFF” before starting
	playback (Z pg. 38 and 39).
6
		Start recording
		Press REC ( ƒ) on the recording VCR.

NOTE:

Be sure to select “AUTO” for “PICTURE CONTROL” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”) after you finish dubbing the tapes (Z pg. 38 and 39).

HR-S4800U/S3800U-EN44-53 46 00.1.31, 10:02 AM