JVC HR-S5900AM System Setup, Access G-CODE Showview Setup Screen, Number, EN Timer Recording

26ENTIMERRECORDING

G-CODE™/SHOWVIEW™

System Setup

Turn on the TV and select the VIDEO channel (or AV mode).

The G-CODEtimer programming system eliminates the need to input channel, date, start and stop time data when setting the timer record function. Simply key in the G-CODEnumber for the TV programme you wish to record (found in most TV listings) and the recorder's timer is automatically programmed.

You have to set "GUIDE PROG" numbers, which are assigned to each station for purposes of G-CODEtimer programming, for all the stations stored in your recorder's memory to get proper results.

Before G-CODEsystem setup you must have performed the following procedures:

●Tuner setting ( pg. 8, 54)

●Clock setting ( pg. 12)

INFORMATION

G-CODEand SHOWVIEW are different trademarks used to represent the same easy recording feature, but only the term G-CODEsystem will be used in the instructions. If you use the SHOWVIEW system, follow the same instructions listed for the G-CODEsystem.

NUMBER

OK

MENU

PUSH JOG

IMPORTANT

Perform the following procedure after Auto Set Up on page 8 and/or the channel setting steps on pages 54– 57.

After setting the Guide Program Numbers, channel positions may be incorrect if you stored or skipped channels. In this case, re-perform Guide Program Number setting.

Guide Program Number Set

ACCESS MAIN MENU

SCREEN

1Press MENU.

ACCESS INITIAL SET

SCREEN

2Press PUSH JOG %fi to place the pointer next to "INITIAL SET", then press OK or PUSH JOG #.

ACCESS G-CODE/

SHOWVIEW SETUP

SCREEN

3Press PUSH JOG %fi to place the pointer next to "G-CODE/SHOWVIEW SETUP", then press OK or PUSH JOG #.

	ENTER GUIDE PROG
4	NUMBER
	Press PUSH JOG %fi or	G-CODE/SHOWVIEW SETUP
	NUMBER keys to enter the
	Guide Program number for	GUIDE PROG	TV PROG
	the desired station as shown	2	5
	in the TV listings. Then press
	OK or PUSH JOG #.	[0-9] OR [5/∞]:SELECT =
		[MENU] : EXIT