EditingTroubleshooting
Editing To/From Another Recorder
Player
40 | 10- |
|
32 |
|
|
RF OUT | IN | OUT |
K | AUDIO |
|
|
| |
G |
|
|
ANT. | VIDEO |
|
IN |
|
|
1- |
|
|
Audio/Video signals
Problem | Check point |
No power | Is the power cord plugged |
| in? |
| Is the power turned on? |
Tape cannot be ejected | Was the video cassette |
| player’s ¤button pressed? |
No picture | Is the TV set to the video |
| channel? |
| Is a cassette loaded? |
| Are the connections correct? |
|
|
No colour | Set the Colour System Out- |
| put switch according to the |
| recorded tape system. |
Shuttle search does not | Is the video cassette player |
function | in the playback mode? |
Disturbances in playback | Is tracking adjusted properly? |
picture | Is the TV adjusted properly? |
| Install this VCP a little way |
| apart from the TV set. |
Remote control does not | The batteries are weak. |
40 |
32 |
RF OUT |
K |
G |
ANT. |
IN |
1- |
Recorder
TV |
Receiver |
10- 
IN OUT
AUDIO
VIDEO
VIDEO CHANNEL
function | Replace the batteries. |
Auto playback does not | The video cassette’s record- |
function | ing safety tab has not been |
| removed. |
Recording does not func- | Are the connections correct? |
tion | Was the Record button |
| pressed? |
| The video cassette’s record- |
| ing safety tab is removed. |
The video cassette player | Microcomputer malfunction. |
does not function properly | Disconnect the power plug |
| from the AC outlet and then |
| |
| The microcomputer will be |
| reset to its initial mode. |
1 Connect the player’s AUDIO and VIDEO OUT connectors to the recorder’s AUDIO and VIDEO IN connectors.
2 Put the player in the Play mode.
3 Put the recorder in the Record mode.
Notes:
∙NTSC tapes being played back in the NTSC PLAYBACK ON PAL TV mode cannot be dubbed to another recorder.
∙When you dub an NTSC tape using your recorder as the playback deck, select NTSC 3.58 (or 4.43) with the Colour System Output switch.
Important:
7To edit, both the player and the recorder must be of the same colour system. Press your recorder’s Colour sys- tem switch to select the appropriate colour system.
About Head cleaning
7If the picture playback becomes blurred, it does not mean that the recorded program has been erased.
7Dirt accumulated on the video heads after long periods of use causes such troubles. In this case, head cleaning requiring highly technical care is necessary.
7For head cleaning, consult the nearest JVC dealer.
10