JVC HR-VP682U DBS Receiver Brand Setting, 40 EN, Turn on the DBS receiver, Operate DBS receiver

40 EN MULTI-BRAND REMOTE CONTROL (cont.)

DBS Receiver

Brand Setting

This Remote can control some functions of the DBS (Direct Broadcast Satellite) receivers listed below.

1 Turn on the DBS receiver

Turn on the DBS receiver using the Power button on the DBS receiver or its Remote.

2 Enter DBS receiver brand code Follow the example shown below.

2–14

CABLE/DBS 1

4

7

1

2

5

8

0

3

POWER

2–2

3

	2	2–3
6

9Number

4

2–4

ENTER

1Press and hold CABLE/DBS.

2 Press MBR SET.

3 Press the Number keys to enter your DBS receiver’s brand code by referring to the table below.

4 Press OK, and release CABLE/DBS.

The DBS receiver should turn off. If it does, try other operations below (☞ step 3).

●Once you have set the Remote to operate the DBS receiver, you do not have to set it until you replace the batteries from the Remote.

3 Operate DBS receiver

While holding down CABLE/DBS, press one of the following buttons: POWER, TV CH +/–, and Number keys.

●For some brands, you must press ENTER after having pressed the Number keys to enter a channel number.

●To change the DBS receiver’s channels, press TV CH +/– or the Number keys. (The CH +/– button can be used to change the VCR’s channels only.)

TV CH +/–

DBS BRAND NAME	BRAND CODE
JVC (DISH Network)	51
ECHOSTAR (DISH Network)	51
PRIMESTAR	50
SONY (DSS)	41
RCA (DSS)	40

NOTES:

●Depending on the type of DBS receiver, some or all functions cannot be operated using this Remote.

●It’s not possible to operate a DBS receiver not equipped with a remote sensor.

●It's not possible to set the Remote for both your DBS receiver and a cable box at the same time. You can only set the Remote to operate one of these units at a time.

(Ex.) To set the Remote to JVC 51:

CABLE/	MBR SET
DBS	A/B
			E
	5	1	NTER/O		SD	Release
			3	OK
Hold	Press in succession
down