JVC SR-V10U manual Changing Remote Control Code, Set remote control code for Remote

EN 53

Changing

Remote Control

Code

2

	REW	FF
POWER	–	+

CH– /+

PUSH / TURN

	REC LINK			A.DUB
S VIDEO	VIDEO (MONO)L—AUDIO—R				24HR QUICK
					PROGRAM
	DIGITAL TBC/NR	SP	EP	INSERT
			VCR		REC	PAUSE STOP/EJECT

This Remote is capable of transmitting two control codes; one set to respond to A code control signals and another set to respond to B code control signals.

This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR and the Remote to respond to B code control signals.

When using two JVC VCRs, set two VCRs and their Remotes to different codes, so that you can operate these VCRs separately.

1 Set remote control code for Remote

1 Press and hold A/B.

2 Press the Number key “2”.

3 Press OK, and release A/B.

● The Remote now can transmit B code control signals.

2Check remote control code for VCR

Press and hold PLAY ( 3 ) on the VCR for more than 5Ê seconds while the VCR is turned off. The code currently set appears on the display panel.

3 Change code for VCR Press any key on the Remote.

1 2 3

4 5 6

7 8 9

0

2

4

1

1

–1, 3

–2

●The VCR now responds to B code control signals.

●To set the Remote and the VCR back to A code control signals, repeat the same procedure as shown above except pressing the Number key “1” in step 2 of 1.

To control two VCRs with the same Remote

You can control two JVC VCRs by switching the remote control code for the Remote between A and B (☞ step 1), keeping two VCRs to different control codes.

1

3 1–3

●Press the Number key “1” for A code control signals and the Number key “2” for B code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 2 and 3 .)

(Ex.) To set Remote to B code:

MBR SET
A/B		E
		NTER/O
	2		SD	Release
		3	OK
Hold	Press in succession
down