JVC SR-W5U manual Press the Stop button

Random Assemble Editing

The unit (as a playback machine)

7Press the START button.

•Editing begins in programmed order, dubbing continues automatically until the last edit-out point.

•This function shuttle searches from edit-out point to the next edit-in point.

•When editing is completed;

The unit (as a playback machine) : will be in stop mode

The unit (as a recording machine) : will be in recording pause mode

The unit (as a recording machine)

8Press the STOP button.

The unit (as a playback machine)

9Press the R.A.EDIT button.

• R.A. EDIT ends.

To cancel or change in-or-out points

1.After completing step 3, press COUNTER RESET button.

•The last-registered counter number will disappear.

Every press of the COUNTER RESET button erases the last registered number.

•Cancelling and changing the counter value while programming is not possible.

2.Re-do steps from 2 – 3 to change.

●Press the COUNTER/REMAIN button to display the total recording time of each program on the front panel display window.

Every press of the button changes the display as follows:

counter–the tape remaining time –the total recording time of all the segments

●Out-point counter value can be registered only when it is higher than in-point counter value.

●Actual in- or out-point may differ slightly from your scene selection.

●Segments with no registered out-point cannot be executed.

●The total time on the counter display and the added up recording time of each program are sometimes not the same since counter display for in-or out-points doesn't show a numerical value of less than 1 second.

●If it takes more than 5 minutes to search for an in-point, the unit's (as a recording machine) Record Pause mode is cancelled and editing doesn't take place.

●At the beginning /end of the tape in the unit (as a playback machine), Random Assemble Editing is sometimes not available.