Video Channel Set

Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.

2	3
q	5/8 6

STOP/EJECT

EN5

The video recorder is designed to send picture and sound signals via the connected RF cable to your TV on UHF channel 36. After you have turned on the recorder, set your TV to UHF channel 36, fine-tune as necessary, and check if picture and sound being received from the recorder come out clearly or not:

● If clear enough	you don't have to perform the following
	steps.
● If not	UHF channel 36 or neighbouring channels
	may be occupied by local stations. Perform
	the following steps to change the Video
	Channel to another channel between 32 – 40.

Before starting, make sure of the following:

●The recorder's power should be off.

●No cassette should be inserted in the recorder.

●The connected TV's power should be on.

1		SET TV CHANNEL
		Set your TV to a channel between 32 and 40 that you
		want to use as the Video Channel on the TV.
		BRING TEST SIGNAL ON
2		SCREEN
		Hold down the recorder's STOP/EJECT button for more
	than 5 seconds.

		● "– OUT" appears on the display panel.

3		TUNE YOUR RECORDER
		Turn the RF output channel adjustment screw on the
		rear panel of the recorder by using a screwdriver until
		the two vertical bars become as clear as they can be.
		EXIT VIDEO CHANNEL SET
4		MODE
		Press the recorder's STOP/EJECT button again to finish
		the setting.

TEST SIGNAL

The channel on which the screen to the left appear clearly in step 3 is your Video Channel.

To view picture signals from the video recorder, set your TV to the Video Channel.