JVC HR-J240E specifications Activate Repeat, Override Automatic Tracking, Adjust Tracking Manually

EN9

Repeat Playback Manual Tracking

Your video recorder can automatically play back the whole tape 20 times repeatedly.

Your video recorder is equipped with automatic tracking control. During playback, you can override this and adjust the tracking manually by pressing the TV PROG buttons.

1	START PLAYBACK
	Press PLAY.
	ACTIVATE REPEAT
2	PLAYBACK
	Press PLAY and hold for over 5 seconds, then release.
	● The Play indicator ($) on the display panel blinks
	slowly.
	● The tape plays 20 times automatically, and then
	stops.
3	STOP PLAYBACK
	Press STOP at any time to stop playback.

NOTE:

Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.

Information On Colour System

You can also record SECAM signals, or play back a MESECAM tape on this recorder. When a MESECAM tape is played back, "MESECAM" appears on the screen for about 5 seconds.

MESECAM is the designation for tapes with SECAM signals that have been recorded on a MESECAM-compatible PAL video recorder.

OVERRIDE AUTOMATIC

TRACKING

1 Press the recorder's TV PROG + and – simultaneously to engage manual tracking.

ADJUST TRACKING

MANUALLY

2 Press TV PROG + or – to adjust tracking.

RETURN TO AUTOMATIC TRACKING

3 Press the recorder's TV PROG + and – simultaneously to re-engage automatic tracking.

NOTE:

When a new tape is inserted, the recorder enters the automatic tracking mode automatically.

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can play back NTSC tapes.

1	LOAD A CASSETTE
	Insert a cassette recorded in NTSC.
2	START PLAYBACK
	Press PLAY.
	● "NTSC" appears on the screen for about 5 seconds.
	● Some TVs shrink the picture vertically and place
	black bars at the top and bottom of the screen. This is
	not a malfunction on the part of either the video
	recorder or the TV.
	● The picture may roll up and down. This can be
	corrected using the V-HOLD control found on some
	TVs. (This cannot be corrected if the TV does not
	have a V-HOLD control.)
	● The counter and tape remaining time readings will be
	incorrect.
	● During search, still, or frame-by-frame playback, the
	picture will be distorted, and there may be a loss of
	colour.
	● Depending on the type of TV, the top and bottom
	portions of superimposed displays may be cut off
	during NTSC playback.