JVC HM-DR10000EK After Scan Completed, Is displayed on the screen, For about 5 seconds, a

1

2

1

2

– –:– –

1 2 3

4 5 6

7 8 9

0

3

4

4

MENU

3 OK

59

	VIEW CONFIRMATION
4	SCREEN
	After "SCAN COMPLETED"	PR	CH	ID	PR CH	ID
	is displayed on the screen	01	26	BBC1	08	– – – –
		02	33	BBC2	09	– – – –
	for about 5 seconds, a
		03	23	ITV	10	– – – –
	Confirmation screen	04	30	CH4	11	– – – –
	looking like the one on the	05	37	CH5	12	– – – –
		06		– – – –	13	– – – –
	right appears. The stations	07		– – – –	14	– – – –
	your recorder located	[5°55]
		=		: EDIT
	appear on a Confirmation	= [X] : DELETE
	screen — preset positions	[MENU] : EXIT
	(PR), channels (CH) and
	station names (ID – ☞ pg. 63). The blueback screen
	and the programme currently being broadcast by the
	station which is blinking appear alternately for 8
	seconds each.			#button on the
	To view the next page, use the %Þ @
	remote control.
	● The Guide Program numbers will also be set
	automatically during Auto channel Set.
	RETURN TO NORMAL
5	SCREEN
	Press MENU.
	● Using the Confirmation screen, you can skip or add
	preset positions, enter station names and perform
	other operations. Refer to pages 60 – 64 for the
	procedures.
	● Depending on reception conditions, the stations may,
	on occasion, not be stored in order, and the station
	names may not be stored correctly.

IMPORTANT

●In certain reception conditions, station names may not be stored correctly, and auto Guide Program Number Set may not work properly. If the Guide Program numbers are not set properly, when you timer-record a TV programme using VIDEO Plus+, the recorder will record a TV programme of a different station. When program- ming the timer using VIDEO Plus+, be sure to check that the preset position corresponding to the broadcasting station you wish to record has been selected (☞ pg. 18, "VIDEO Plus+® Timer Programming").

●Your video recorder memorizes all detected stations even if reception of some of them is poor. In these cases picture quality may be poor. To delete those stations which have an unacceptable picture ☞ "Delete A Channel" on page 61.

NOTES:

●Fine tuning is performed automatically during Auto Channel Set. If you wish to perform it manually, refer to page 61.

●If, for any reason, you perform Auto Channel Set when the aerial cable is not connected properly, "SCAN COMPLETED -NO SIGNAL-" appears on the screen in step 4. When this happens, make sure of the aerial connection and press OK; Auto Channel Set will take place again.