Magnavox VPA115AT owner manual Mobile Connections

Page 11

Mobile Connections 11

When passengers in your vehicle want to watch a video program, hook up the VCP by following the steps below.

 

 

ANT OUT

 

 

CH3

 

AUDIO

CH4

13.2V

OUTPUT

ANT IN

 

VIDEO

 

AC Power Cord

Car Battery Cord

To 13.2V Jack

(supplied)

To Cigarette Lighter Jack

1

Make sure your vehicle has a 13.2-volt, negative ground electrical system. Unplug the AC power cords of the VCP and the TV.

2

Connect one end of the car battery cord to the 13.2V Jack on the back of the VCP.

3

Connect the other end of the car battery cord to the ciga- rette lighter jack in your vehicle.

4

Follow step 3 on page seven to connect the VCP to a TV.

5

Connect the TV to a DC power source. The TV must have an AC/DC Jack.

Helpful Hints

Do not watch TV while driving.

Use only the supplied car battery cord. Using another cord could dam- age the VCP or cause faulty opera- tion.

Make sure the cigarette lighter jack is free of ashes and other debris.

Make sure you push the car battery cord’s plug completely into the ciga- rette lighter jack.

Always unplug the car battery cord from the cigarette lighter jack before you unplug it from the VCP.

You must disconnect the car battery cord from the VCP before you can use standard AC electrical power.

If the vehicle’s engine is off, there will not be enough electrical voltage to operate the VCP.

Unplug the car battery cord from the cigarette lighter jack when you have finished using the VCP.

Image 11
Contents VPA115AT Model No Serial No Dear Philips Magnavox product ownerFor Customer Use This bolt of lightning indi- cates uninsulated materialIntroduction FeaturesSafety Precautions Table of Contents VCR Maintenance Before Using Your VCPPutting Batteries in the Remote Control Using the Remote ControlDisconnect the antenna or cable from your TV Hookups Without a Cable BoxYou are ready to turn on the VCP Hookups Without a Cable Box cont’dPlug in the TV and the VCP VCP to the TV’s Hookups With a Cable BoxWatching TV with the VCP Off Playing a TapeTV Antenna in Jack Connect a Cable signal to the VCP’s ANTenna in JackHookups With a Cable Box cont’d Helpful Hint Hookups With a Stereo TVMobile Connections Remote Control Buttons Display Panel Front Panel ANTenna in Jack 13.2V Jack AC Power Cord CH3/CH4 Switch ANTenna OUT JackRear Panel Audio Output Jack Video Output JackPlaying PICTurePICTure Control Button Control Light Playback OptionsRepeat Playback Picture ControlViewing a Still Picture Forward and Reverse Searching SP/LP/SLPSuper High Speed Searching LP/SLP Automatic Operation Features Helpful Hints Model # Serial # Limited WarrantyGlossary Specifications/GlossarySpecifications Controls PowerRemote Control Buttons Using Sensor Repeat Light Playback WarrantySupplied Accessories