SU4/UF2
PROGRAM TIMER RECORDING
Checking the Program Timer
1Turn on the power (TV and VCR).
2Set the TV to channel 3 or 4.
3Press the MENU button. The main MENU appears.
4Press the SET button.
The programmed recordings are listed.
NOTE: To display the program type or rating, press the TYPE button after selecting the desired program using the CH/TRACK l (or j) button.
5When finished, press the MENU button to exit the menu.
6Press the POWER button.
The VCR power turns off and the timer is set to the recording standby mode.
The Timer icon (n) appears.
Clearing the Program Timer
1Follow steps 1 – 4 in “Checking the Program Timer”.
2Press the CH/TRACK l (or j) button to select the program to be cleared.
3Press the CLEAR button.
The erase confirmation screen appears.
4Press the CLEAR button again. (To cancel the erase procedure, press the SET button.)
The selected timer program is erased from the program memory.
5When finished, press the MENU button to exit the menu.
6Press the POWER button.
Using Timer Recording for Several Programs
If two or more programmed recording times overlap on the same day, the VCR will not begin recording a new program until the previous program has ended (as shown below).
Program Recording Order
| 7:00PM |
| 8:00PM |
| 9:00PM | 10:00PM | ||
Program
These portions will not be recorded
TIMER SETTING NOTES:
œIf the programmed recording falls on a Saturday or a Sunday, the Daily recording mode will not be possible.
œTo select the A/V recording mode, press the INPUT button instead of selecting a channel number.
œ12:00 PM = noon; 12:00 AM = midnight.
œIf the end of the tape is reached during timer recording, the VCR stops and the power turns off automatically.
œIf the power fails or the VCR is unplugged from the AC outlet, the correct clock time and timer settings are kept in memory for approximately 5 seconds.
After 5 seconds, the clock and program timer must be reset when power is restored. Refer to INITIAL SETUP to set the VCR.
Changing the Program Timer
1Follow the steps under “Clearing the Program Timer” to erase the program that you wish to change.
2Follow the steps under “Timer Programming” to add a new timer program.
34