Arkon manual Rack Mounting the MAX-AVP, Troubleshooting Ethernet Communications

Installation

9.If a disc is in the local drive, MENU will invoke the DVD Menu.

Troubleshooting Ethernet Communications

In case of Ethernet communications problems, check the following:

The Link (L) LED next to the Ethernet port should be on (FIG. 2). If not, check your cables and connectors.

Connect a display device to the AVP to view the Configuration Page for the IP settings (IP Address and Subnet Mask), and verify that these settings are appropriate for your network configuration.

Refer to the MAX Servers Instruction Manual (available online at www.amx.com), as well as the individual Installation Guides for details and installation instruction on MAX Servers.

Rack Mounting the MAX-AVP

The MAX-AVP comes with rack-ears, to allow mounting the unit in a standard 19" equipment rack - the AVP will take up a single rack space.

The rack-ear kit includes two steel rack ears and eight sets of flat washers, split lock-washers, and nuts.

The MAX-AVP rack-ears (FIG. 3) feature four mounting posts, to provide a clean installation. These mounting posts require that the rack-ears are secured to the unit from inside the chassis, so you will have to remove the cover, as described below:

Rack-mounting holes

(secure the chassis and rack-ears to the equipment rack)

Mounting Posts (secure the Rack-Ear to the chassis)

FIG. 3 MAX-AVP rack-ears

1.Turn off the AVP, and disconnect the power cord and all connecting cords.

2.Place the unit face up on a soft and dry flat surface.

3.On the rear panel, remove the four screws that secure the top of the enclosure to the bottom (FIG. 4) and keep them in a safe place for further use:

Remove the four screws that secure the top of the chassis to the bottom

FIG. 4 Remove the four screws that secure the top of the enclosure to the bottom