Arkon MAX-AVP manual HDMI-to-DVI Conversion Cable MDL200 Kit

Installation

Secure the rack-ears to the inside of the chassis

front

FIG. 7 Secure the rack-ears to the inside of the chassis

8.Put the chassis sections back together and secure the two sections with the four screws removed earlier.

9.Remove the "feet" from the bottom of the unit. Each foot is secured to the chassis with a single screw. Keep the feet and screws for further use.

Once the rack-ears have been installed, the AVP can be mounted into the equipment rack.

HDMI-to-DVI Conversion Cable (MDL200 Kit)

The MAX MDL200 Multi Disc Loader System comes as a kit that includes a PowerFile Multi-Disc Loader, a Windows® PC pre-loaded with all required software, pre-configured for plug and play operation, equipped with a LCD monitor, keyboard and mouse.

Refer to the MAX MDL200 Multi Disc Loader System Installation Guide and Operation/Reference Guide (available online at www.amx.com) for detailed instructions on using the MDL200 kit to bulk-load media to a MAX Server.

The HDMI-to-DVI conversion cable allows you to connect the LCD monitor that comes with the MDL200 kit directly to a MAX-AVP Audio-Video Player, to access the AVP’s Setup Pages.

Options in the AVP’s Setup pages allow you to complete initial configurations on the AVP, including:

Audio and video output settings

Fine tuning options (such as brightness, contrast and saturation)

Localization settings (including Region Code settings)

Refer to the Setup Page section on page 46 for details on configuring the MAX-AVP.

You do not need the conversion cable to use the MDL200, it is included with the kit so that you can use the LCD monitor to configure a MAX-AVP. Note that the MAX-AVP is not part of the MAX-MDL200 kit.

To connect the LCD monitor to a MAX-AVP, use the conversion cable to connect the HDMI output on the AVP to the DVI input on the LCD monitor.

To access the AVP’s setup pages, press the SETUP button on the AVP remote.