Fisher FVH-T610 important safety instructions Alternative Cable TV Connections

SC4H/UF (FVH-T610 GB) Fri. Jan., 07/2000

ALTERNATIVE CABLE TV CONNECTIONS

Your VCR can receive all unscrambled cable channels without the use of an external converter. If you wish to view and record scrambled cable channels, you must connect a converter/decoder as described below.

Your local cable TV company will advise you of the channels available in your area.

We recommend that you consult your cable TV company to make sure that the cable is properly connected.

When the TV does not have a built-in cable converter

Connect the cable TV converter between the VCR and the TV so that you can watch a cable TV program while recording another program.

NOTE: Set the TV channel to the cable converter output channel (CH02 ~ 07).

CATV	VCR		Cable	TV
	(Back	panel)	converter	(Back	panel)
75 ohm
coaxial		VHF/UHF		VHF/UHF
cable		FROM ANT.		ANTENNA
			IN	OUT	IN
		IN
		TO TV
		OUT
	AC IN
			(supplied)	(not supplied)

When you have both cable and pay TV (scrambled channels)

NOTES:

œWith this method the TV and VCR receive the same channel. Recording one program while watching another is not possible.

œWith this connection, the VCR must be set to the cable converter/decoder output channel. (See next page.)

Cable	VCR		TV
converter/	(Back	panel)	(Back	panel)
Decoder		VHF/UHF	VHF/UHF
		FROM ANT.	ANTENNA
				IN
		IN
CATV		TO TV
75 ohm		OUT
coaxial cable	AC IN
			(supplied)

NOTE TO CATV SYSTEM INSTALLER (USA only): This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular,

specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practicable.

11