GETTING STARTED
Press the Power |
| button to operate the STB from the STANDBY mode. |
| ||
|
| ||||
|
| ||||
Now, the Info box will appear for a given time and disappear. Pressing the |
|
| button, | ||
| |||||
the Info box will remain on the screen. The display time of the Info box is adjustable | |||||
under the I n s t a l l a t i o n Menu of the M a i n Menu. |
| ||||
If the current broadcast has EPG (Electronic Program Guide) with it, press the | button | ||||
to see not only the current channel’s but also other channel’s EPG without any time constraints.
Also, press the 
button to reserve and save the current service and to watch the broadcast automatically when it starts.
IMPORTANT: Before taking charge of your new STB, some important technical
settings are essential.
-Adjust your antenna through Dish Setting menu in installation menu.
-First, press the 
button on the RCU to make the M a i n Menu appear.
-Go to the LNB Setting menu under the Channel Search item of the
Installation menu and press 
button.
-The Default PIN CODE is 0 0 0 0.
-Choose the right parameters for Satellite Name, LNB Frequency, 22KHz, 12 V, DiSEqC 1.0, and Motorized System according to your LNB and satellite settings. If the right Satellite Name and LNB Frequency were not found in the list, call the dealer for satellite information.
-Then, press the 
button and go back to the Channel Search menu.
-Set the Search Mode to the A u t o mode. (A Manual or Advanced Search can always be performed later on)
-Select the Start Search... item and press 
button.
-The search procedure will take a while. Press the 
button when the searching process is over (100%) to confirm and save the new channel list.
-For further information, please refer to the LNB Setting item of the MENU OPERATIONS on this manual.
GETTING STARTED