Rosen Entertainment Systems RVR 2000 owner manual DVR Manual Recording, Four record durations are

Rosen DVR Owner’s Manual

DVR MANUAL RECORDING

Manual recording to the DVR is only allowed for recording and archiving of DVDs which you own. There are three available quality modes for recording as well as four different record dura- tions.

The three quality modes are BEST, BETTER, and GOOD. Depending on the output fi le format set by the DVD player, the available hard drive space for video recording will vary.

The default recording format in the T10/T12 overhead system is 16:9 widescreen.

For dock recording in the home, the format is set by your source input device.

Source output format is 16:9 Widescreen.

	Minutes Per	Total Hours	Full Length
	GB *	per DVR **	Movies ***
BEST	30	10	6
BETTER	60	20	12
GOOD	120	40	25

*May be lower if source output is 4:3 Pan Scan or Letterbox ** Actual formatted capacity may vary.

*** Based on an average of 90 minutes per movie.

The four record durations are:

Continuous: Records until a STOP or EJECT command is sent or the DVR runs out of hard disk drive space.

30 Minute: Records for 30 minutes and stops automatically.

60 Minute: Records for 60 minutes and stops automatically.

90 Minute: Records for 90 minutes and stops automatically.

Load a DVD and begin playback. At the point where you wish to begin recording, change source to the DVR.

For Dual Zone Systems, T10/T12:

If the system is setup for DUAL ZONE, press PAUSE to pause playback and then change source to the DVR. In the DVR source, navigate to the “RECORDING” menu icon and press ENTER. This will bring up the recording window with selectable options at the bottom of the screen and the video image of the Internal DVD source in the background. At this point the video from the Internal DVD should be paused. Before recording, select the desired quality and duration. The DVD should be commanded to start playback before recording starts. This can be done through the DVR RUI by pressing the SYS- TEM MENU button on the T10/T12 remote control or by pressing and holding the DOWN button on the CPM for 2 seconds. Navigate to the “Play DVD” option and press ENTER. Playback will begin and the menu should close. At this time, recording can be started by select- ing the “RECORD” option at the bottom of the screen and pressing ENTER. Recording will be confi rmed by a “REC” OSD from the DVR and a record status that indicates the recording time elapsed as well as the record quality and duration selected. To stop recording, press the STOP button on the remote or EJECT on the CPM. To pause DVD playback, bring up the RUI and select “Pause DVD.” To view the recorded fi le, go back to the DVR main menu, navigate and select the VIDEO icon and then locate the fi le. Once the fi le is located and highlighted, press PLAY to begin video playback.

18