Rosen Entertainment Systems 410X Installation and Wiring Before Starting, Package Contents

Page 13

Installation and Wiring

1. Before Starting

Read these instructions and the following precautions carefully.

WARNING!

Be sure to disconnect the battery (-) terminal before starting. This is to prevent short circuits during installation.

Precautions

•This unit is exclusively for cars with a negative ground, 12V power supply.

•Do not open the case. There are no user-serviceable parts inside. If you drop anything into the unit during installation, consult your dealer or an authorized Rosen service center.

•Use a soft, dry cloth to clean the case. Never use a rough cloth, thinner, benzene, alcohol, or other solvent. For tough dirt, apply a small amount of cold or warm water to a soft cloth and gently wipe.

2. Package Contents

•410XR disc unit

•IR Remote control

•4-pin Power Supply harness

•RCA Audio Cable

•Additional IR Receiver (with cable)

•Installation Brackets and Assorted Hardware

•Owner’s Manual / Installation Guide

•Warranty Card

3. Installation Requirements

1 Install the unit within 30 degrees of the horizontal plane.

Max. 30˚

2Use the enclosed screws for installation. Using other screws can cause damage and void the warranty.

ChassisChassis

Damage

Max. 8 mm (M5 screw)

410X 13

Image 13

Contents Table of Contents About InstallationIntroduction Accessories Supplied withAbout the Registered Marks FCC Approval Care and MaintenanceHandling Discs LiquidsDiscs Played by Temperature and MoistureDiscs Compatible with DVD RegionsDiscs Incompatible with UsingRegion Icons Previous Front-Panel ControlsUsing the Remote Control Remote ControlInserting a DVD/VCD/CD DVD/VCD/CD-AUDIO PlaybackDisc Playback Stopping PlaybackRepeat Mode Pausing PlaybackFast Searching During Playback Viewing Angles Parental Control MP3 Playback on CD-R Discs What is MP3?MP3 Playback Supported MP3 File FormatsFile Extensions Package Contents Installation and Wiring Before StartingInstallation Requirements Installing into the DIN Sleeve InstallingRemoving the 410X from the DIN Mounting Sleeve Installing into a Fixed In-Dash MountSome cases the factory trim panel may require some slight Wiring 410X Rear-panel Connections Only USE the FOUR-PIN Connector Supplied with this UnitFM Mod 410X in a typical system410X Typical Setup and Configuration SetupChanging Settings Changing the Video Output Mode Changing the Aspect Ratio ModeActivating Captions and Subtitles Concealing the Angle MarkSelecting an Lpcm Output Frequency Activating the Digital OutputDeactivating the Smart Nav On-Screen Menu Display Changing Language SettingsTo change the disc menu language, select Preferences General Setup Options ListSpecifications TroubleshootingTinny sound Picture rolls