Rosen Entertainment Systems 410X specifications Installing into the DIN Sleeve

Page 14

4. Installing the 410X

Installing into the DIN Sleeve

First, verify that the opening you will be mounting the 410X into will accommodate the mounting sleeve.

Sleeve opening dimensions

7-3/16" (182 mm) mm)

Hole (531/16" -2

Note:

•Some car models require special mounting kits for proper installation. Consult your Rosen/necvox dealer for details.

1Place the sleeve into the instrument panel opening. Ensure a tight fit.

2Bend the tabs of the sleeve inward as shown to lock the sleeve into place.

3Wire the power harness, make all connections to the 410X (see “Wiring the 410X”), and plug in the power harness.

4Gently insert the 410X into the mounting sleeve until it locks into place with a ‘click.’

5Clip the trim ring into place.

14410X

	Rear fastening hole of vehicle,
	or backstrap
	Instrument panel
	Hole
Bend tabs to
lock sleeve into place	Nut and washer
	Rear mounting bolt

DIN mounting sleeve

Tabs

DIN sleeve clip

Trim ring

Image 14

Contents About Installation Table of ContentsAbout the Registered Marks Accessories Supplied withIntroduction Handling Discs Care and MaintenanceFCC Approval LiquidsDiscs Compatible with Temperature and MoistureDiscs Played by DVD RegionsRegion Icons UsingDiscs Incompatible with Front-Panel Controls PreviousRemote Control Using the Remote ControlDisc Playback DVD/VCD/CD-AUDIO PlaybackInserting a DVD/VCD/CD Stopping PlaybackFast Searching During Playback Pausing PlaybackRepeat Mode Viewing AnglesParental Control MP3 Playback What is MP3? MP3 Playback on CD-R Discs Supported MP3 File FormatsFile Extensions Installation Requirements Installation and Wiring Before StartingPackage Contents Installing Installing into the DIN SleeveInstalling into a Fixed In-Dash Mount Removing the 410X from the DIN Mounting SleeveSome cases the factory trim panel may require some slight Wiring Only USE the FOUR-PIN Connector Supplied with this Unit 410X Rear-panel Connections410X in a typical system FM ModChanging Settings Setup410X Typical Setup and Configuration Changing the Aspect Ratio Mode Changing the Video Output ModeConcealing the Angle Mark Activating Captions and SubtitlesActivating the Digital Output Selecting an Lpcm Output FrequencyChanging Language Settings Deactivating the Smart Nav On-Screen Menu DisplayTo change the disc menu language, select Preferences Setup Options List GeneralTinny sound TroubleshootingSpecifications Picture rolls