3M 7620-T-95 manual Remove semi-conductive jacket to dimension shown in Figure

12.5 Remove semi-conductive jacket to dimension shown in Figure 17.

NOTE: To ease jacket removal, install constant force spring as shown in Figure 17 and ring cut 80% through jacket. Remove jacket sections by pulling against constant force spring. DO NOT BELL SEMI-CON JACKET. Remove constant force spring.

NOTE: It is imperative to remove all remnants of the semi-conductive jacket, even if the semi-conductive jacket comes off as one layer. There should not be any remaining black areas, or particles, on the cable insulation layer.

Depth Of Terminal Lug + Growth Allowance

4 3/4" (121 mm)

2" (51 mm)

1" (25 mm)

Semi-Conductive Jacket

Cut Line

Constant Force Spring

Fold Back Shield Wires

Figure 17

13.0Install Ground Braid

13.1Select a Scotch® Mastic Strip 2230 from kit and remove white release liners. Using light tension, apply a

single wrap of mastic around the cable semi-conductive jacket 1/4" (6 mm) from shield wires (Figure 18). Cut off excess.

1/4" (6 mm)
	Semi-Con
	Shield Wires
1ST	Scotch® Mastic Sealing Strip 2230

Figure 18

78-8113-5098-8 Rev F 13