3M 7620-T-95 manual Instructions For Tape Shielded Cable, Prepare Cable

Instructions For Tape Shielded Cable

2.0Prepare Cable

2.1Check to be sure cable size fits within kit range as shown in Table 1.

2.2Prepare cable using dimensions shown in Figure 1. Be sure to allow for depth of terminal

lug. If necessary to prevent tape shield from unrolling, hold down edge with a single wrap of 3M™ EMI Copper Foil Shielding Tape 1181.

NOTE: Provide additional 1/4" (6 mm) exposed conductor distance to account for growth during crimping of ALUMINUM lugs or connectors.

NOTE: It is imperative to remove all remnants of the semi-con layer, even if the semi-con layer comes off as one layer. There should not be any remaining black areas, or particles, on the cable insulation layer.

2.3Select a Scotch® Mastic Sealing Strip 2230 from kit and remove white release liners. Using light tension, apply a single wrap of mastic around the cable jacket 1/4" (6 mm) from cut edge (Figure 1). Cut off excess.

	Jacket Removal Length
	Depth Of Terminal Lug + Growth Allowance
	6 3/4" (171 mm)
	2" (51 mm)
1/4" (6 mm)	1" (25 mm)
	Semi-Con
	Tape Shield
Cable Jacket	1ST Scotch® Mastic Strip 2230

Figure 1

78-8113-5098-8 Rev F 3