Sherwood RX-770 manual Introduction, Read this Before Operating Your Unit

Page 2

Introduction

READ THIS BEFORE OPERATING YOUR UNIT

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR

BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Note to CATV System Installer :

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as pracitcal.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the the user’s authority to operate the equipment.

FOR YOUR SAFETY

U.S.A

CANADA

120 V

Units shipped to the U.S.A and Canada are designed for operation on 120 V AC only.

Safety precaution with use of a polarized AC plug.

However, some products may be supplied with a nonpolarized plug.

CAUTION : To prevent electric shock, match wide blade of plug to wide slot, fully insert.

ATTENTION : Pour éviter chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’ au

fond.

Avoid high temperatures. Allow for sufficient heat dispersion when installed on a rack.

Keep the set free from moisture, water, and dust.

Do not let foreign objects in the set.

Handle the power cord carefully. Hold the plug when unplugging the cord.

Unplug the power cord when not using the set for long periods of time.

Do not obstruct the ventilation holes.

Do not let insecticides, benzene, and thinner come in contact wth the set.

Never disassemble or modify the set in any way.

2

Image 2
Contents Page Introduction Read this Before Operating Your UnitSafety Instructions Contents System Connections Digi Link Front Panel & Remote Controls Digi Link III System Remote ControlsTUNING/PRESET Mode Button Power ButtonStandby Indicator Speaker A, B Selector Buttons TUNING/PRESET UP/DOWN ButtonsFluorescent Display Tape Deck SectionRemote Sensor Operations Listening to a Program SourceAdjusting the sound volume balance Auto tuning Listening to Radio BroadcastsTuning to preset stations Memory Backup FunctionRecording Other FunctionsTroubleshooting Guide Problem Possible Cause RemedySpecifications Amplifier Section