Sherwood RX-770 Power Button, Standby Button, Standby Indicator Speaker A, B Selector Buttons

Page 8

POWER BUTTON

In the standby mode, press this button, then this unit is turned on to enter the operating mode.

STANDBY BUTTON

In the operating mode, press this button or the POWER button on the front panel, then this unit is turned off to enter the standby mode.

STANDBY INDICATOR

SPEAKER A, B SELECTOR BUTTONS

These buttons allow you to select various combinations of speakers as follows:

To drive A speakers, press only the SPEAKER A button (“SPK A” is displayed).

To drive B speakers, press only the SPEAKER B button (“SPK B” is displayed).

To drive both A and B speakers, press the SPEAKER A(or B) and B(or A) buttons in order.(“SPK A B” is displayed).

When using headphones for private listening, press these buttons in order to switch off the speaker A and B (“SPK OFF” is displayed).

HEADPHONE JACK

Stereo headphones with a standard 1/4 inch plug can be plugged into this jack for private listening.

INPUT SELECTOR BUTTONS

Press the button to select the desired input source.

TONE BUTTON

When adjusting the tone (bass and treble), press this button to select the desired tone mode.

Each time this button is pressed, the tone mode is changed to bass or treble.

BALANCE BUTTON

When adjusting the sound volume balance, press this button to enter the balance mode.

BALANCE, TREBLE/BASS UP/DOWN

() BUTTONS

At the balance mode, adjust the sound volume balance between left and right speakers with these buttons.

At the desired tone mode, adjust the tone as desired with these buttons.

TONE DIRECT BUTTON

Press this button to listen to a program source without the tone effect.

MEMORY BUTTON

Press this button to store preset stations.

TUNING/PRESET MODE BUTTON

Press this button to select the tuning mode or the preset mode.

NUMERIC BUTTONS(0 ~ 9)

Press these buttons to select or to store preset stations directly.

TUNING/PRESET UP/DOWN( BUTTONS

Press these buttons to tune in the desired stations.

FM MODE BUTTON

Press this button to select the desired FM mode. Each time this button is pressed, the FM mode is changed to the stereo mode or the mono mode.

PRESET SCAN BUTTON

Press this button to scan the stations in the preset sequence.

VOLUME CONTROL KNOB, UP/DOWN( ) BUTTONS

Adjust the volume to a comfortable listening level with this knob or these buttons.

MUTE BUTTON

Press this button to temporarily mute the sound. Press again to resume the previous sound level.

DIMMER BUTTON

Press this button to select the brightness of the fluorescent displays as desired.

Each time this button is pressed, the brightness of all fluorescent displays changes together as follows:

ON dimmer OFF

SLEEP BUTTON

Press this button to activate the sleep timer for a specified period of time.

Each time this button is pressed, the sleep time changes as follows:

10 20 30 60 90 OFF Unit : minutes

CD PLAYER SECTION

-to begin play

- to pause play

REPEAT A/B - to play a specific part repeatedly

, - to skipping backward or forward

-to stop play

INTRO - to preview each track only for 10 seconds

8

Image 8
Contents Page Introduction Read this Before Operating Your UnitSafety Instructions Contents System Connections Digi Link Front Panel & Remote Controls Digi Link III System Remote ControlsPower Button Standby Indicator Speaker A, B Selector ButtonsTUNING/PRESET Mode Button TUNING/PRESET UP/DOWN ButtonsFluorescent Display Tape Deck SectionRemote Sensor Operations Listening to a Program SourceAdjusting the sound volume balance Auto tuning Listening to Radio BroadcastsTuning to preset stations Memory Backup FunctionRecording Other FunctionsTroubleshooting Guide Problem Possible Cause RemedySpecifications Amplifier Section