Setup
Connections
Please refer to “Basic TV Connection” on the front page before you use this unit.
RF Output Channel
If channel 3 has been already occupied for broadcasting,
1)Set your TV to channel 4.
2)Insert a
VCR OUTPUT light is lit.
•If noise appears on the TV screen, press [VCR/TV] on the remote control.
4) Press [PLAY B] once.
5)After a few seconds, press and hold [PLAY B] on the unit for seconds.
•The RF output channel will change to channel 4 from channel and you will see a playback picture.
•When a picture does not appear on the TV screen, repeat step 4.
6)Press [STOP C] to stop playback.
Hint
•The RF output channel may change when you adjust tracking during play- back. In this case, stop the playback, and start the playback again. After that, press and hold [PLAY B] on the unit for seconds again.
Setup
Hint for Cable Box or Satellite Box
| (Cable box or |
| (Back of DVD/VCR) | |
|
|
| ||
|
| Satellite box) |
| |
Satellite or | IN | OUT |
| RF cable |
Cable TV |
|
| ||
|
|
|
| |
signal |
|
|
| (supplied) |
|
|
|
| (Back of TV) |
Select this connection when you want to view or record a scrambled channel. With this connection, channels cannot be changed on the unit. You can view or record ONLY
the channels you have selected on the cable box or the satellite box.
• While you are recording, only the recorded channel can be viewed.
To select channels of the cable box or satellite box
1)Turn on the unit by pressing [POWER], then press [VCR/TV]. The POWER indicator on the front panel will light, then press [SKIP/CH. G/K, H/L] to select chan- nel or 4 (the same channel as the output channel of the cable box or satellite box).
•If you use the channel 4, you need to change the unit’s RF output to channel 4. Refer to “RF Output Channel”.
2)At the TV, select channel or 4 (the same channel as you have selected at step 1).
) On the cable box or satellite box, select the channel you want to view or record.
Connection to an Audio System
| Method 1 |
|
Audio | Stereo system |
|
| Analog audio | |
| L R | |
|
| input jacks |
Audio cable |
| |
(supplied) |
|
|
| DVD/VCR | VCR |
| AUDIO OUT |
|
AUDIO OUT | L |
|
|
|
Method 2
Dolby Digital decoder, MD deck or DAT deck
COAXIAL Digital audio input jack
Audio Coaxial
Digital cable
(commercially
available)
DIGITAL | DVD | |
AUDIO | ||
|
| COMPONENT |
AUDIO OUT | OUT | OUT |
(Analog) | R |
|
DVD/VCRor
DIGITAL | DVD | |
AUDIO | ||
|
| COMPONENT |
AUDIO OUT | OUT | OUT |
L
R
(DVD mode only)
Hint
DIGITAL COAXIAL
AUDIO OUT
Setting
Connection
Connecting to a Dolby Digital decod- er for Dolby Digital audio output.
Connecting to the other equipment (an MD deck or DAT deck etc.) with- out Dolby Digital decoder.
SETUP > QUICK> DOLBY DIGITAL
BITSTREAM
PCM
•Playing a DVD using incorrect settings may generate noise distortion and may also damage the speaker.
*To complete these settings, refer to pages 20-21.
•The audio source on a disc in a Dolby Digital Multi channel surround format cannot be recorded as digital sound by an MD or DAT deck.
•By hooking this unit up to a Multi channel Dolby Digital decoder, you can enjoy
•Playing a DVD using incorrect settings may generate noise distortion and may also damage the speakers.
– 6 – | EN |