Hitachi DV-RX7000E Unpacking, Connecting Scart Cable, Accessory, Method 1 Antenna + DVD Recorder

Page 15

Step 1: Unpacking

Accessory

Check for the supplied accessories below.

Video/Audio Cable

RF Cable for TV

Remote Control

Batteries for Remote Control (AAA Size)

Instruction Manual

Dispose of batteries according to local environmental regulations. Do not put them in the household trash.

Step 2: Connecting

SCART Cable

There are several ways to connect your DVD Recorder using scart cables.

The AV1 connector can output both video signal (composite video, RGB video) and audio signal (stereo analog).

The AV2 connector accepts (composite video, RGB video) and audio signal (stereo analog).

The AV1 connector accepts composite video and audio signal.

The AV2 connector can output composite video and audio signal.

Select one of the following connections that best suits you.

Method 1: Antenna + DVD Recorder + TV

Method 2: Antenna + VCR/satellite receiver/cable box + DVD Recorder + TV

Method 3: Antenna + DVD Recorder + external decoder box + TV

If a SCART cable is plugged into the AV1 (TV) NOTE output SCART connector, any device plugged into

the AV3 IN (AUDIO/VIDEO) jacks will be unus- able: Use the AV4 IN jacks on the front panel.

If you are using an off-air antenna that has 300- ohm twin flat leads, use an external antenna con- nector (300-75 ohm adaptor: not supplied) to con- nect the antenna to the DVD Recorder.

If you have two separate antennas (one VHF and the other UHF), use a UHF/VHF combiner-adap- tor (available at most electronics shops) to con- nect the antenna to the DVD Recorder.

 

The VHF/UHF RF OUT jack of this product sends

 

 

only signals received through the antenna. It does

 

 

not output audio/video signals.You must connect

 

 

audio/video cables to view Video from the unit.

 

 

(i.e. DVD playback)

English

 

 

 

Method 1: Antenna + DVD Recorder

 

 

 

 

+ TV

 

You can connect your DVD Recorder to the television using the SCART cable if the appropriate input is available on the television.You thus:

Obtain better quality sound and pictures

Simplify the setting up procedure of your DVD Recorder

1.Connect the coaxial cable as shown.

2.Connect one end of the SCART cable to the AV1 socket on the rear of the DVD Recorder.

3.Plug the other end into the appropriate connector on the television.

2

3

Regardless of the type of connection chosen, you

NOTE

must always connect the coaxial cable supplied.

 

Otherwise, no picture will be visible on the screen

 

when the DVD Decorder is switched off.

Make sure that both the television and the DVD Recorder is switched off before connecting the cables.

If you want to record one channel while watching another channel on TV screen, press TV/DVD button.

English - 15

Image 15
Contents Example DVD RecorderImportant Safety Instructions PrecautionDisc Handling Maintenance of CabinetDisc Specifications Handling CautionsMP3 CD-R/RW Copy Protection Contents Additional Information General Features Recorder Before ReadingCreating a playlist DVD-RAM/-RW in VR mode Using a DVD-RAMUsing a DVD-RW Using a DVD-RDescription Front PanelFront Panel Display Rear Panel Tour of the Remote ControlReturn Button ? REC Mode ButtonCancel Button Repeat A-B Button OK/DIRECTION Buttons UP/DOWN or LEFT/RIGHT ButtonsQuick Overview Connecting the Power Cord Preparing the Remote ControlMethod 1 Antenna + DVD Recorder Connecting Scart CableAccessory UnpackingMethod 3 Antenna + DVD Recorder + external decoder box + TV Method 2 Connecting to an S-video output jack Method 1 Connecting to a Composite Video output jackOther type of connect- ing the Audio output cable Method 1 Connecting to your TVConnecting to AV3, AV4, DV input jack Panel of the DVD Recorder Method 2 Connecting a Camcorder to the AV 4 Input jacksMethod 3 Connecting a Camcorder to the DV in jack You can also use the AV4 in jacks on the frontSetting the Remote Control Preparing the Remote ControlOff Used to switch the television onIf several codes are indicated for your television Button FunctionOK Button On-Screen Menu NavigationMenu Button Up/Down and Left/RightPlug & Auto Set up Connect the coaxial cable as indicated onAuto Channel scan will be started Clock Set Check the date and timeSelect System the 34 buttons, then press the 1 or OK button Auto Setup Auto ClockSee page 15 Connections Manual Setup Refer to following table when selecting your countryPress the 342 1 buttons to select your Country Select Edit, Delete, or Swap CM Skip Time SettingSelect Setup using 34 buttons, then press the 1 or OK button Setting Up Nicam OptionsLanguage setup menu will be displayed Setting UpOptions Language Features You cant use the Setup functions during disc playbackSetting Up the Audio Options ButtonDisc Menu Language For the disc menu contained on the disc Output from Analog Audio Output This function allows you to setup the TV screen settingsDigital Output Dynamic Compression3D Noise Reduction motion adaptive noise reduction Setting Up the Parental ControlDisplay Video Options TV Aspect‘Confirm the password.’ message will be displayed About the Change PasswordBefore Recording Recordable discsThis recorder can record on the following discs Unrecordable pictures Recording ModeConcerning Copy Control Signals Recording FormatsAbout INFO. Key Checking the available disc space Disc InformationPress the OPEN/CLOSE button to close the disc tray To pause recording Press the Prog / or numberProgram you want to record Press the REC buttonSource while recording Front panel display changes in the following sequencePress the Stop button to clear the time slip function Press the Time Slip button during DVD- RAM recordingPress the REC button to adjust the recording time TV Program 1 toOTR appears on the front panel display Mode Recording Mode Making a Standard TimerPress the OK button Editing a Standard TimerPress the OK button to confirm the edited setting Deleting a Standard TimerSelected entry will be deleted from the list Using the Showview FeatureShowview Extended Press the Menu buttonWith the DVD in Stop press the Menu button Displayed Timer Recording MessagesWhen the start time in the Standard Timer list arrives, if the set is in powerStop To stop RecordingDiscs that cannot be played Before PlayingRegion code DVD-Video only Disc types that can be playedPlaying a Disc Press the OPEN/CLOSE buttonPress the Stop button to stop playback Press the Title List button to move to the Title List Using the Disc & Title MenuUsing the Search Functions Searching through a Chapter or TrackAbout Anykey Searching Chapters or TracksSlow Motion Play Step Motion PlayPress the Repeat button Using the Repeat FunctionPlaying Repeatedly Repeat Playback Press the 34 buttons to select the TimePress the Repeat button repeatedly to select Off Press the Anykey buttonRepeat playback of the A-B section starts Press the Repeat A-B buttonPress the OK button again to set end point B Press the Anykey button. Repeat is highlightedPress the Subtitle button during playback Selecting the SubtitleAre disc-specific Selecting the Audio languageChanging the Camera Angle Press the Audio button during playbackZooming-In Press the Anykey button during playback or pauseNormal size 2X 4X 2X B a==============--b Press the PIP button repeatedly to select Off Using PIP Picture in PicturePress the PIP button Press the PIP button againNumber 1 is displayed and the scene is memorized Using BookmarksPress the OK button when the desired scene appears Press the Marker button during playbackPress the Marker button Using MarkersPress the Cancel button to delete the selected bookmark Clearing a BookmarkClearing a Marker Playing Back a MarkerAudio CD CD-DA Screen Elements Buttons on the Remote ControlPlaying an Audio Playing an Audio CD CD-DAPlaying a MP3 Disc MP3 Screen ElementsInsert a MP3 Disc into the disc tray Play Option Mode To Program Tracks Select Play Option using the 2 1 buttonsSelect Playlist using the 34 buttons Playing a Picture CD OK or 1 buttonCase of playing a Picture CD, see number 3 on Next Playing the Title List Press the 342 1 buttons to select a picturePress the Title List button To stop title play, press the Stop button Play, Rename, Delete, Edit, Protection See pages 71~74Edit menu is displayed on the right Movie Title List Screen ElementsEditing Renaming Labeling a Title Using the Menu buttonBasic Editing Title ListDeleting a Title Locking Protecting a TitleDeleting a Section of a Title Title List screen will disappear Press the OK button at the end pointPress the Menu button after the operation has finished Selected section has been deletedAdvanced Editing Play List Creating a PlaylistPress the OK button at the start point Playlist entries will be played Playing Entries in the PlaylistPress the Play List button Press the Stop button to stop playingEnter the desired characters using 342 1 buttons Renaming a Playlist EntryPress the 34 buttons to select Playlist, and then Editing a Scene for the Playlist Playing a Selected SceneButtons Press the OK button at the start point of the scenePress the OK button at the end point of the scene Modify Scene screen is displayedAdding a Scene Press the OK button at the starting point of the sceneSelected scene is moved to the selected position Deleting a Scene Copying a Playlist Entry to the PlaylistPlaylist that has been selected at last will be copied Numbers Deleting a Playlist Entry from the PlaylistPress the Menu button with the disc stopped Enter the desired characters using the arrow buttonsDisc Manager Editing the Disc NameDVD-RAM only Disc ProtectionFormatting a Disc Tection has been clearedPossible Editing Partial editing is Not available Delete All Title ListsCartridge Protect Info All title lists are deletedIs set to Not Protected Finalizing a disc Disc is finalizedFrom the record list DVD-Video Unfinalizing a disc V/VR modeSame as OperationAdditional Information Troubleshooting Other Forget my password for parental Timer Timer lamp flickersTimer recording does not work Remote control Remote control doesn’t workAudio Output SpecificationsHitachi Atago Building