Synchronous Recording
Recording Playback Signals From a VCR with RS-422A
Signal Connections
Synchronous Recording |
|
Recording Playback Signals From a VCR with |
|
|
Editing Via the REMOTE CONTROL (9PIN MASTER/DV MASTER) Screen |
A keyboard and mouse can be used as an alternative to the DVD recorder’s buttons when using the REMOTE CONTROL (9PIN |
MASTER/DV MASTER) screen. |
VIDEO IN
LAN
SIGNAL
GND
VIDEO OUT |
|
| ||
| AUDIO IN | AUDIO OUT | VIDEO OUT | |
|
|
| ||
VIDEO | AUDIO |
|
|
|
IN LINE OUTINPUT | CH1 |
|
|
|
LEVEL | IN | OUT |
|
|
| 4dB |
|
|
|
| 8dB | AUDIO OUT |
|
|
IN |
|
|
| |
Y/C |
|
|
|
|
|
|
|
| Variable Motion |
| CH2 |
|
|
|
| REMOTE |
|
|
|
DV IN/OUT |
| REMOTE |
|
|
USB | DC 19V |
|
|
Front panel | : | Select using the cursor buttons (t, 8, 7, and 6), and confirm the selection using the SET button. |
Keyboard | : | Select using the arrow keys (†, ©, √, and ∞), and confirm the selection using the Enter key. |
Mouse | : | Left click the required button. |
*When the REMOTE CONTROL screen is being displayed, the DVD recorder’s, FWD, REV, PLAY, REC, PAUSE, MENU, and TOP MENU buttons will be disabled.
In Point (start point for editing): | Out Point (end point for editing): |
Set the time code (hours : minutes : seconds : frames) of | Set the time code (hours : minutes : seconds : frames) of |
the position on the playback tape where recording is to | the position on the playback tape where recording is to |
be started. | be stopped. |
|
| USB terminal | VCR with an | |
|
|
| ||
|
|
|
| MONITOR OUT |
Keyboard |
|
| ||
|
| - | * - |
|
|
|
| + |
|
|
|
| Mouse |
|
|
|
| Monitor | Monitor |
● Connect the | ||||
|
| |||
● Connect the DVD recorder’s VIDEO LINE IN and AUDIO IN terminals to the VCR’s video out and audio out terminals. | ||||
● Connect the DVD recorder’s VIDEO LINE OUT and AUDIO OUT terminals to the monitor’s video in and audio in terminals. | ||||
● A keyboard and mouse can be used as an alternative to the DVD recorder’s buttons when using the REMOTE CONTROL screen. | ||||
If used, these are to be connected to each of the USB terminals on the rear panel. |
| |||
Setup Procedures |
|
| ||
● Insert the tape for playback into the VCR. Ensure that this tape contains an SMPTE time code. |
| |||
● Insert a recordable disc into your |
| |||
| Settings |
|
| |
VCR | : | Enable control via |
| |
: | Set REMOTE SELECT from the REMOTE MENU screen to 9PIN (MASTER). |
|
Chapter list: |
|
|
|
|
|
|
|
|
|
|
|
|
| TC INPUT: |
| ||
This displays the time |
|
|
|
| REMOTE CONTROL SCREEN ( 9PIN MASTER ) | This field is used to input | |||||||||||
codes | of | chapter |
|
|
|
| time codes | for the In | |||||||||
| EXIT | IN POINT 00:00:00:00 | OUT POINT | 00:10:00:00 | |||||||||||||
marks. |
|
|
|
| Point, Out | Point, and | |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
● The In Point’s time |
|
| h : | m: | s : f |
| h : m: | s : f |
| h : m: s : f | chapter marks from the | ||||||
code is registered as |
|
|
|
| keyboard. |
| |||||||||||
| 1 | 00:00:00:00 | 2 | 00:15:00:00 | 3 | 00:20:00:00 |
| ||||||||||
the | first | chapter |
|
|
| ||||||||||||
| 4 | 00:25:00:00 | 5 | 00:30:00:00 | 6 | 00:35:00:00 |
|
| |||||||||
mark. |
|
|
|
|
|
| |||||||||||
|
|
|
| 7 | 00:40:00:00 | 8 | 00:45:00:00 | 9 | 00:50:00:00 | DISC REMAIN: | |||||||
● A total of 98 chapters |
| ||||||||||||||||
|
|
|
|
|
|
| TC INPUT | : | : : | ||||||||
|
|
| CHAPTER | MANUAL | This field | shows an | |||||||||||
can be setup. |
|
|
|
| |||||||||||||
|
|
|
|
|
| ||||||||||||
|
| ADJ |
|
|
|
|
|
|
| 000 min | estimate of the remaining | ||||||
● When | CHAPTER |
| BITRATE | 8.0 Mbps | DISC REMAIN |
| |||||||||||
CREATION from the |
|
| TC SET |
| EDL LOAD |
|
| FINALIZE | space for recording on the | ||||||||
|
|
|
|
| disc. |
| |||||||||||
RECORDER MENU |
|
|
|
|
|
| |||||||||||
| TC CANCEL | EDIT/END |
|
|
|
|
| ||||||||||
|
|
|
|
|
|
| |||||||||||
(2/2) screen is set to |
|
|
|
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| |||||
MANUAL, it will be |
|
|
|
|
|
|
|
|
|
|
| FINALIZE: |
| ||||
possible to setup |
|
|
|
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
| This button is used to | ||||||
chapter marks at any |
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
| finalize the disc. | ||||||
position | on | the |
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
| |||||
playback tape. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
| ADJUST: |
|
|
|
| TC SET | : | This button is used to set input time codes for | ||||
|
|
|
|
|
| This button | can | be |
|
|
|
| the In Point, Out Point, and chapter marks. | ||||
|
|
|
|
|
| pressed to determine |
| TC CANCEL : | This button is used to remove setting values | ||||||||
CHAPTER: |
|
|
| the remaining disc time |
| EDL LOAD |
| for the In Point, Out Point, and chapter marks. | |||||||||
The | based on the editing |
| : | This button is used to load the | |||||||||||||
the | current | setting | for | time and to also set a |
|
|
|
| edit list. It can be used whenever CREATION | ||||||||
CHAPTER CREATION from | suitable bit rate. This |
| EDIT/END |
| CHAPTER has been set to MANUAL. | ||||||||||||
the RECORDER MENU (2/2) | setting | is | then |
| : | This button | is used to star t editing |
REMOTE MENU screen | |
REMOTE MENU |
|
MENU |
|
REMOTE SELECT | 9PIN(MASTER) |
REC CONTROL | OFF |
REM FF/REW MODE | FF/REW |
Note When pressing and holding the REC button more than 2 seconds while the DVD recorder is stopped, encoded output images can be checked while the button is being held.
●When REMOTE SELECT is set to 9PIN (MASTER), the REMOTE CONTROL (9PIN MASTER) screen will appear. This screen is used to perform editing operations, and the corresponding operations are described on the following pages.
REMOTE CONTROL (9PIN MASTER) screen | |||||||||||||||
EXIT |
| REMOTE CONTROL SCREEN ( 9PIN MASTER ) | |||||||||||||
| IN POINT | 00:00:00:00 | OUT POINT | 00:10:00:00 | |||||||||||
|
| h | : m: s : f |
|
| h : m: | s : f |
| h : | m: s : f | |||||
1 | 00:00:00:00 | 2 | 00:15:00:00 | 3 | 00:20:00:00 | ||||||||||
4 | 00:25:00:00 | 5 | 00:30:00:00 | 6 | 00:35:00:00 | ||||||||||
7 | 00:40:00:00 | 8 | 00:45:00:00 | 9 | 00:50:00:00 | ||||||||||
|
|
|
| CHAPTER | MANUAL | TC INPUT | : | : | |||||||
ADJ | BITRATE | 8.0 Mbps | DISC REMAIN |
|
| 000 min | |||||||||
|
|
| |||||||||||||
|
|
|
| EDL LOAD |
|
|
| FINALIZE | |||||||
| TC SET |
|
|
|
| ||||||||||
TC CANCEL | EDIT/END |
|
|
|
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
screen. | displayed in the BIT | automatically. When recording has ended, the | |
● When set to MANUAL, | RATE field. | DVD recorder automatically adopts Recording | |
chapter marks can be |
|
| STOP mode. If selected while editing, this |
|
| ||
registered in this screen’s |
|
| button will end that process. |
chapter list. |
|
|
|
|
|
| |
● When set to AUTO, the |
|
|
|
DVD recorder’s chapter |
|
|
|
VCR Control Panel |
|
|
| ||||||
chapters. In such a case, it | The buttons provided in this panel are used to control VCR operations. When a | ||||||||
will not be possible to | button is selected and confirmed, the VCR will carry out the corresponding operation. | ||||||||
register chapters using this | It is important to remember that these buttons do not control operation of this DVD | ||||||||
screen’s chapter list. | recorder. |
|
|
| |||||
● Chapter marks | are | e | : | Eject | w | : | Pause | ||
inserted at GOP intervals | |||||||||
u : | Fast reverse or | t | : | Play | |||||
(i.e., 15 frames). It will not | |||||||||
| : |
| : | ||||||
be possible to | inser t | q | : | Stop | y : | Fast forward or | |||
chapter marks that are | |||||||||
* | The action to be taken by the DVD recorder in response to pressing of the y or | ||||||||
closer together than this | |||||||||
| u button (i.e., FF/REW or SEARCH) is selected using REM FF/REW MODE | ||||||||
interval. |
|
|
| ||||||
|
|
| from the REMOTE MENU screen. |
|
|
| |||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
59 | 60 |