LG Electronics LRA-516 owner manual Reset the Recorder

Symptom	Cause	Solution
Cannot play a disc	The disc was recorded in Video mode.	Finalize the disc. (page 25)
recorded using this
	Some players will not play even a final-	No solution.
recorder on another
	ized disc recorded in Video mode.
player.
	The disc was recorded in VR mode.	The other player must be RW com-
		patible in order to play it.
	Discs recorded with copy-once material	No solution.
	cannot be played on other players.
Cannot record or did	The remaining blank space on the disc	Use another disc.
not record successfully.	is insufficient.
	The source you are trying to record is	You cannot record the source.
	copy protected.
	When setting the recording channel, the	Select the channel on the recorder’s
	channel is tuned on the TV’s own tuner.	built-in TV tuner.
	When recording to a Video mode disc,	Use a VR mode formatted disc for
	programs that are copy-once protected	copy-once material.
	cannot be recorded.
Timer recording is not	Clock in recorder is not set to correct	Set clock to correct time.
possible.	time.
	Timer has been programmed	Reprogram Timer.
	incorrectly.
	(Timer record) indicator light does	Reprogram Timer.
	not appear after programming timer.
Stereo Audio Record	TV is not Stereo-compatible.	No solution.
	Broadcast program is not in stereo for-	No solution.
and/or Playback is not
	mat.
present.
	The recorder A/V Out jacks are not	Make A/V connections. Stereo is
	connected to TV A/V In jacks.	available only via A/V output from the
		recorder.
	The recorder Audio/Video Out is not	Select AUX or A/V source as TV
	selected for viewing at the TV.	input.
	The recorder’s TV audio channel is set	Set TV audio channel mode to
	to mono.	Stereo. See [Changing TV audio
		channel] on page 27.
	The Remote Control is not pointed at	Point the Remote Control at the
The Remote Control	the remote sensor of the recorder.	remote sensor of the recorder.
does not work properly.	The Remote Control is too far from the	Operate the Remote Control within
	recorder.	7 m.
	There is an obstacle in the path of the	Remove the obstacle.
	Remote Control and the recorder.
	The batteries in the Remote Control	Replace the batteries with new ones.
	are exhausted.

Reset the Recorder

If you observe any of the following symptoms...

When the Recorder is plugged in, but the power will not turn on or off.

When the display window does not working. When the Recorder does not operate normally.

You can reset the Recorder as follows :

Press and hold the (POWER) button for more than five seconds. This will force the Recorder to power off.

Press the (POWER) button again to turn the Recorder back on.

Unplug the power cord and then plug the power cord again after more than five sec- onds.

Reference

53