LG Electronics DRT389H manual Recording, Resetting the unit

Page 38

DR386M-P.BGBRLLK_ENG 6/13/08 9:59 AM Page 38

Recording

Cannot record or does not record successfully.

bCheck the remaining space on the disc.

bCheck that the source you are trying to record in not copy protected.

bThe power may have failed during recording.

bUse a VR mode formatted disc for copy-once material.

Timer record does not record successfully.

bClock is not set to correct time.

bThe start time of the timer recording is past.

bTwo timer recordings may have overlapped, in which case only the earlier one will record completely.

bWhen setting the recording channel, make sure you set the unit’s built-in tuner, not the TV’s built-in tuner.

Stereo Audio Record and/or Playback is not present.

bTV is not Stereo-compatible.

bBroadcast program is not in stereo format.

bThe A/V Output jacks on the unit are not connected to TV A/V In jacks.

HDMI

The connected HDMI device does not display any picture.

bTry disconnecting then reconnecting the HDMI cable.

bTry switching the power of the HDMI device off then back on.

bThe video input of the connected device is set correctly for this unit.

bThe HDMI cable you are using is fully HDMI-compliant . Using a non-stan- dard cable may result in no picture being output.

bNot all HDCP-compatible DVI devices will work with this unit.

The connected HDMI device does not output sounds.

bSome HDMI-compatible devices do not output sounds (check the manual that came with the connected device).

bIf your TV is not capable of handling 96 kHz sampling frequency, set the [Sampling Freq.] option to [48 kHz] on the setup menu. When this choice is made, this unit will automatically convert any 96 kHz signals to 48 kHz so your system can decode them.

bIf your TV is not equipped with Dolby Digital and MPEG decoder, set the [Dolby Digital] and [MPEG] options to [PCM] on the setup menu.

bIf your TV is not equipped with DTS decoder, set the [DTS] options to [OFF] on the setup menu. To enjoy DTS multi channel surround, you must connect this unit to a DTS compatible receiver via one of this unit’s digital audio outputs.

Resetting the unit

If you observe any of the following symptoms.

The unit is plugged in, but the power will not turn on or off.

The front panel display is not working.

The unit is not operating normally.

You can reset the unit as follows.

Press and hold the POWER button for at least five seconds. This will

force the unit to power off then turn the unit back on.

Unplug the power cord, wait at least five seconds, and then plug it in

again.

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents DRT389H Disposal of your old appliance Copyrights Open source software noticeContents Playable discs Before you startRecordable and Playable discs Setting up the remote to control your TV About the Symbol Display Regional CodesRemote Control Operation Restrictions on copyingRemote control V / V left/right/up/downMain Unit Antenna Antenna Digital Analog And/or Hooking up the unitAntenna connection to your TV Component connection Hooking up the unit more you can doGeneral about connection Video connection Digital audio connectionAbout Hdmi What is SIMPLINK?Hdmi connection RecorderConnecting a PAY-TV/Canal Plus Decoder Connecting to the AV2 Decoder jackUsing USB Flash Drive more you can do Operating USB Flash DriveAdjust the programmed channels Auto setupAuto setup more you can do Editing a channel Analog channel onlyUsing the Home Menu Setting a favorite programEasy Menu Adjust the Setup settingsUsing the Home Menu more you can do RecordAdjust the Setup settings more you can do Adjust the general settingsAdjust the language settings Adjust the audio settings Adjust the lock settings Adjust the recording settingsAdjust the disc settings RAMAdjust the network settings Displaying disc information Displaying disc Information more you can doChanging TV program Switching the program listDisplaying information while watching TV Changing TV program with program listSwitching the EPG menu Using the digital EPGUsing the digital EPG more you can do About the digital EPGPlay a disc Play a disc more you can doFast forward or fast reverse DVD ALL ACD DivX Pause a playbackFrame-by-Frame playback DVD ALL Hearing a different audio DVD ALL DivXPlaying DivX movie files Playing a DivX movie files more you can doListening to a music Listening to a music more you can doViewing a photo Viewing a photo more you can doRecording Instant timer recordingSetting a timer record Recording more you can doEditing a title Editing a title more you can doDeleting a title or chapter Before editingAdding chapter markers -RWVR+RW +R RAM Making a new Playlist -RWVRRAMProtect a title -RWVR+RW +R RAM Hiding a chapter or title +RW +RDividing a title +RW Deleting a part -RWVRRAMNaming a title Using the Disc menuViewing Title List menu displayed on another unit +RW +R Overwriting +RWLanguage Codes Area CodesPlayback TroubleshootingGeneral Resetting the unit RecordingInputs SpecificationsAccessories OutputsGuarantee Technology with the human touch
Top Page Image Contents