Connecting the IR control cable
The Recorder sends commands to your connected
1.Connect the plug of the IR control cable to the IR TRANSMITTER jack on the Recorder.
2.Find the
3.On the IR control cable, attach the adhesive tape (included) to the flat surface just below of the IR Blaster on the IR control cable.
4.Place the IR Blaster in front of the IR sensor on your
5After connecting, make the necessary setting (page 25).
ANTENNA OUT
Cable Box,
Satellite Box
Digital Video Recorder or
Other
VIDEO AUDIO OUT
OUT
IR Blaster
Front
IR
Control
Cable
Notes:
•If your
•Important, for the Recorder to record programs received through the
•If your
•Do not connect an accessory other than the sup- plied IR control cable to the IR TRANSMITTER jack.
•Do not cover the transmitter.
•Not all
•Refer to the owner’s manual of the connected
Caution:
Do not use RF coaxial cable to connect the
Rear of Recorder
How to find the IR sensor on the Set-Top Box
1.Turn off the
2.Hold the Remote Control of the
YesNo
3.Slowly move the Remote Control across the front of the device while pressing POWER button On and Off. You must press and release the POWER button each time you move the Remote Control (holding down the button will not work).
Recommended Set-Top Box devices
Cable Box: Motorola, Pioneer, Scientific Atlanta, Sony
Satellite Box: DirecTV, Echostar, Dish NetWork, HTS, Hughes, JVC, Proscan, RCA, Sony
Digital Video Recorder: Tivo, DirecTV,
Dish NetWork, Scientific Atlanta, Motorola,
Hughes, Humax, Philips, Sony
4.When the cable box turns on, you have found the sensor. Remember the location of the sensor.
18