Other Operations
Presetting the Radio Stations
You can preset 50 stations for FM and AM (MW). Before tuning, make sure that you have turned down the vol- ume.
1 | Press FM/AM on the remote control until FM or | |
AM (MW) appears in the display window. | ||
2 | And then every time you press FM/AM, FM and | |
AM (MW) changes alternately. | ||
| Press and hold TUN.- | or TUN.+ on the |
3 remote control for about three seconds until the | ||
| frequency indication starts to change, then | |
| release. |
|
| Scanning stops when the Recorder Combi Receiver tunes | |
| in a station. “TUNED” and “S.” (for stereo program) | |
| appear in the display window. | |
4 | Press ENTER on the remote control. | |
A preset number will flash in the display window. | ||
| Press TRK/PRESET- | or TRK/PRESET- on |
5 the remote control to select the preset number | ||
| you want. |
|
| Press ENTER on the remote control. | |
6 The station is stored. |
| |
7 | Repeat steps 3 to 6 to store other stations. |
To tune in a station with a weak signal
Press TUN.- or TUN.+ repeatedly in step 3 to tune in the station manually.
To clear all the stored stations
Press and hold ENTER for about two seconds and “MEM CLEAR” is appeared in the display window and then press ENTER again, the stations are cleared.
If you have accidentally entered into the "MEM CLEAR" mode and you do not wish to clear the mem- ory, do not press any key. After a few seconds, the "MEM CLEAR" display will go off by itself and change to normal mode.
68