ADS Technologies USB Instant DVD Audio/Video Delay Parameters, Video Capture Timing, Control

CAPTURE WIZARD STEP-BY -STEP

Menu Options

Audio/Video Delay Parameters

We have worked hard to ensure that audio and video are in synch, but it is hard to predict everyone’s system configuration and timing.

If the audio and video are not in synch you can adjust the timing here.

Note:

1.Make adjustments with No Video Playing

2.Make small adjustments.

3Change only one setting at a time; only audio or only video.

4.Make small adjustments.

5.Watch the video carefully during capture and playback so you can properly determine if audio is ahead of the video or if the video is ahead of the audio.

6.Watch both the preview and the captured

video. Often times the preview may be slightly off, but the recorded file is fine.

7.Most corrections can be made by changing ONLY the Audio timing.

8.During long captures you may see the lip synch drift off a bit and then return to normal a few minutes later. This will most likely not affect your recording.

9.If you mess up, click the Reset button to return to factory default settings.

Video Capture Timing:

Making an adjustment here will control audio and video timing during preview and capture.

1.Slide Audio or Video delay slider.

2.Click the Audio or Video button to set.

3.Click OK.

4 Click Preview to see the change.

5.Repeat steps 1-4 until you have perfect lip synch.

Video Playback Timing:

Making an adjustment here will control audio and video timing during preview and capture. 1.) Slide Audio or Video delay slider.

2.) Click the Audio or Video button to set.

3.) Click OK.

4.) Click Preview to see the change.

5.) Repeat steps 1-4 until you have perfect lip synch.

Control

The Control menu gives you another way to control video recording and playback:

The selections are: Preview, Record, Stop, Pause Play

Applications

The Applications menu gives you another way to jump to bundled applications and you can also change the path of these applications if you happened to install them on a different drive.

1.Click the Applications menu button

2.Click on MyDVD or Video Studio to Jump to the selected application. Capture Wizard will automatically close when you do this.

3.Click the Edit button. This will show the default or standard directory path the applica- tions are normally installed.

4.To change the directory path click the box with the “…” and you can browse to the directory path you installed the application.

25

CapWiz manual.p65 25 6/4/2002, 12:22 PM