Barracuda 4LP Installation Guide, Rev. B | 37 |
N drives
Terminating the drive
“N” model drives are terminated with permanently mounted IC active terminators. If you install one of these drives and it is not on the end of the SCSI bus, disable the terminators by removing the jumper “TE” from pins 15 and 16 of connector J2 (see Fig- ure 8). If you install the drive on the end of the SCSI bus, enable termination by installing a jumper on pins 15 and 16 of connector J2.
Pin 1
J2 | R |
| T D M W P E T T |
| E S E P D S P P |
Enable SCSI terminator
Disable SCSI terminator
(default)
| J6 | J2 |
| SCSI I/O J1 | |
|
| |
|
| Connector |
| Drive |
|
J2 Jumper Type | Front |
|
| DC Power | |
(enlarged to |
| |
| Connector | |
show detail) |
| |
|
|