Seagate ST32171N/W/WC/WD/DC, ST34571N/W/WC/WD/DC manual Setting terminator power jumpers

Page 40

38	Barracuda 4LP Installation Guide, Rev. B

N drives

Terminator power

There are three possible terminator power (TP) configurations for “N” model drives (see Figure 9). You will not normally need to change this option and can leave the drive configured as it was shipped from the factory.

	J2	R
	“N” model drives	T D M W P E T T
	“N” model drives	E S E P D S P P
	Term. Power from Drive
	Term. Power to SCSI Bus
	Term. Power from SCSI Bus
		Position A
	J6	J2
	J6	SCSI I/O
		SCSI I/O
		Connector
	Drive
	Front
	J2 Jumper Type	DC Power
	(enlarged to	DC Power
	show detail)	Connector

Pin 1

(default)

J1

Figure 9. Setting terminator power jumpers

Image 40

Contents Barracuda 4LP Disc Drive Contents Preface Electrostatic discharge protectionImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Barracuda 4LP Installation Guide, Rev. B European Union Compliance SeaFONE at 1-800-SEAGATE Seagate Technology online servicesSeaNET Seagate CompuServe Forum SeaBOARDBBS Location Modem number Seagate Technology FAX services SeaFAX Seagate technical support FAXSeagate technical support Location Telephone numberSeaTDD General description Drive characteristics RPMDC power requirements Amps ST34371/ST34571 Single-ended DifferentialDC power requirements Amps ST32171/ST32271 Dimensions of the drive Drive models General informationScsi ID jumpers Drive termination Terminator power Circuits and data path widthsCable characteristics for single-ended circuits Fifty pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Barracuda 4LP Installation Guide, Rev. B Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der KabelBarracuda 4LP Installation Guide, Rev. B DC power connector Abbildung 5. Gleichstromanschluß Hinweis Page Mounting configuration dimensions Formatting the drive Quick reference desktop system notesSetting the Scsi ID jumpers Setting the Scsi ID on model N drivesTerminating the drive Terminating the driveSetting terminator power jumpers Other applicable jumper options Additional jumper optionsWD drives Host Alternate Terminating the drive W model shown Front DC Power Enlarged to Show detail Connector Other option jumpers are available as illustrated below WC/DC drives Applicable jumper options Jumper optionsPage Page