Swann SW242-DAL, SW244-DAO manual Motion Set

Page 14

 

 

 

 

User Manual

5.14 Motion Set

 

 

MOTION RECORD TIME:

 

 

 

 

 

 

This number indicates how many

 

 

 

seconds the motion detection recording

MOTION SET

 

lasts after the DVR has detected motion.

MOTION RECORD TIME:

10

 

 

MOTION ALARM TIME:

OFF

MOTION ALARM TIME:

MOTION SET

 

 

This number indicates how many

 

 

seconds the buzzer/alarm inside the DVR

 

 

 

PRESS (UP, DOWN),

ENTER

will sound after the DVR has detected

(SELECT)

 

 

motion.

PRESS (MENU) TO

EXIT

 

CONT: Continuous alarm until press any key is pressed when motion detected.

OFF: No alarm

MOTION SET:

MOTION DETECTION SET

>CHANNEL 1 SENSITIVITY 4 CHANNEL 2 SENSITIVITY 4 CHANNEL 3 SENSITIVITY 4 CHANNEL 4 SENSITIVITY 4

CHANNEL 1 AREA SET

CHANNEL 2 AREA SET

CHANNEL 3 AREA SET

CHANNEL 4 AREA SET

PRESS (UP, DOWN), ENTER

(SELECT)

PRESS (MENU) TO EXIT

AREA SET:

SENSITIVITY:

Use [Up] and [ Down] button to highlight the channel you want to modify and press [SEL] to adjust sensitivity of motion detection on each channel.

High (1----------

9, OFF) Low

When “OFF”, the channel will not

detect motion or trigger motion recording.

Use [Up] and [ Down] button to select the channel you want to modify and press [SEL] button to enter the sensitive area of each camera. The picture of the selected channel is divided into 144(12*12) blocks, press [REW] to move left, press [FWD] to move right, press[Up] and [ Down] to move the cursor up and down, press [SEL] to set the highlighted block active or disabled.

When the block is transparent, it’s active or set to detect motion. When the block is covered by a shadow, it is not active and motion will NOT be detected.

Make sure Record Schedule is set to Motion for the times required.

- 11 -

Image 14
Contents DVR4-Alert Plus Table of Contents Recording AppendixFront Panel DVR FeaturesOverview Remote Control Rear PanelConnecting the Power Supply Installing Hard DriveConnecting Camera and Monitor Restore Recording Feature Detecting Installed Hard DriveRecovering Lost Data Starting the DVRMain Screen DVR SetupSetup Menu Camera Select Record SelectResolution Record FrameRecord Quality Schedule SetMiscellaneous Menu-Color Set Miscellaneous Menu-Password ChangeMiscellaneous Menu-Auto Record Miscellaneous Menu-Time Set Hard Disk SetMotion Set Recording Video ModeFactory Reset Start RecordingStop Recording Recording Time on Hard DrivePlayback Program buttons USB ProgrammingPC Viewer Program PC Backup RemarkSpecifications DescriptionAppendix