Swann SW244-DAO, SW242-DAL manual Video Mode, Factory Reset, Start Recording

Page 15

User Manual

5.15 Video Mode

Select NTSC (North America) or PAL (Europe/Australia) video system.

5.16 Factory Reset

Press [SEL] button to reset the DVR to factory defaults. The DVR will reboot and all custom settings (including password) will be restored to default.

Caution: There is no confirmation dialog box for this selection after you

press [SEL] button.

If you have forgotten your password and would like to reset, press [Pause] button 10 times to reset DVR to factory default. Then the default password is now: [CH1] button 6 times.

If you are unable to stop recording, you must unplug the power supply and remove the HDD, then reboot the DVR and press [Pause] button for 10 times.

Chapter 6: Recording

6.1 Start Recording

Press [REC] to start recording (as set in 5.7 Schedule Set).

DVR will display system information on screen.

10% 1

2

R

R

3

1 2 R

3 4 R

4

5

6

7

8

EACH REC [M] (T) 2008/07/01 16:22:30

- 12 -

Image 15
Contents DVR4-Alert Plus Table of Contents Appendix RecordingDVR Features OverviewFront Panel Rear Panel Remote ControlInstalling Hard Drive Connecting Camera and MonitorConnecting the Power Supply Starting the DVR Detecting Installed Hard DriveRecovering Lost Data Restore Recording FeatureDVR Setup Setup MenuMain Screen Record Select Camera SelectRecord Frame ResolutionSchedule Set Record QualityMiscellaneous Menu-Password Change Miscellaneous Menu-Auto RecordMiscellaneous Menu-Color Set Hard Disk Set Miscellaneous Menu-Time SetMotion Set Start Recording Video ModeFactory Reset RecordingRecording Time on Hard Drive Stop RecordingPlayback USB Programming PC Viewer ProgramProgram buttons Remark PC BackupDescription SpecificationsAppendix