Swann SW244-DAO, SW242-DAL Starting the DVR, Detecting Installed Hard Drive, Recovering Lost Data

Page 7

User Manual

Chapter 4: Starting the DVR

MASTER…

After connecting the power, the system will boot-up and detect the installed hard drive.

On the screen it will show the hard drive information. If no hard drive is detected, check that the HDD is set to master and the tray is locked.

RECOVER HDD?

04811-101735

(SELECT)YES/(MENU)NO

A power failure can cause data to be lost,

however the DVR system will automatically

recover lost data after power is reconnected.

Power Error Detected

Restore Hard Disk (Master) OK

Restore REC Mode………… OK

If a power error occurs during recording process, the system will automatically resume recording after power is reconnected.

- 4 -

Image 7

Contents DVR4-Alert Plus Table of Contents Appendix RecordingOverview DVR FeaturesFront Panel Rear Panel Remote ControlConnecting Camera and Monitor Installing Hard DriveConnecting the Power Supply Starting the DVR Detecting Installed Hard DriveRecovering Lost Data Restore Recording FeatureSetup Menu DVR SetupMain Screen Record Select Camera SelectRecord Frame ResolutionSchedule Set Record QualityMiscellaneous Menu-Auto Record Miscellaneous Menu-Password ChangeMiscellaneous Menu-Color Set Hard Disk Set Miscellaneous Menu-Time SetMotion Set Start Recording Video ModeFactory Reset RecordingRecording Time on Hard Drive Stop RecordingPlayback PC Viewer Program USB ProgrammingProgram buttons Remark PC BackupDescription SpecificationsAppendix