Custom Labels, 16 RR-969, Reset Button, Button Labels

16RR-969

3.If necessary, press the – key until the “TRX” is flash- ing and press the ENT button to confirm. The TRANS-

MITTER and indicators along with the word “SEND- ING” appear in the display confirming that data is being sent. It takes 10 minutes to send all of the data.

4.When the data has been completely transferred, the “OK” confirmation appears in the display and the remote returns to normal operating mode.

NOTE: Cancel the clone function by pressing the /CLONE button again.

Once the transfer has started, the following information appears in the display of the receiving RR-969:

1.The LOADING indicator appears during the actual data transfer, which takes ten minutes.

2.If the data transfer is successful, the “OK” prompt appears and the unit returns to normal mode.

3.If corrupted data is received, the CLONE REPT in- dicator advises you to repeat the procedure.

4.If no data is received for 60 seconds in receive mode, “NO DATA” appears in the LCD and the unit reverts to normal operating mode.

NOTE: Do not attempt to use the CLONE function to transfer data from any remote other than another Rotel RR-969.

Reset Button

Should the RR-969 stop functioning , press the RESET button with the tip of a ballpoint pen. The clock settings will be lost, but all learned commands will be retained.

Custom Labels

Whenever you press a button on the RR-969, its name appears in the display. By default, the labels match the printed labels for each button. You can change the la- bels that appear when a button is pressed – to change the language or to customize the labels to match your specific components.

There are two complete sets (“pages”) of labels stored in the RR-969. You can switch between the two. We rec- ommend that you not change the first page of labels. Use the second page to enter custom labels. This al- lows you to return to the default labels at any time.

English 17

Multi-language Mode

To switch from the first page of labels to the second page, press the recessed LANG–PAGE 1/2 button with the tip of a ballpoint pen. Press the button again to toggle back to the first page. The new selection, either “PAGE 1” or “PAGE 2” appears briefly in the display.

Button Labels

To change the label for a button:

1.Press a DEVICE button to select the command set for which you wish to change the labels. For example, press TUNER to change the labels that appear when a button in the TUNER command set is pressed.

2.Press the EDIT button . The prompt “EDIT?” ap- pears in the display.

3.Press the DEVICE or COMMAND button you wish to relabel. The current label appears in the display with the first letter flashing.

4.Press the UP or DOWN buttons to change the flashing letter, stepping through the list of characters. Press the “X” button on the numeric keypad to insert a blank space in the label.

5.Press the – or + button to move to the next charac- ter in the label.

6.Repeat steps 4 and 5 to complete the new label, which is self-centering in the display.

7.To label another button, press another DEVICE or COMMAND button and repeat the above steps. The RR-969 saves the new labels and returns to normal mode if no buttons are pressed for 15 seconds. Press the EDIT button to return manually.

NOTE: Different labels can be memorized for a single command button under each of the 10 command sets. Relabeling only changes the command button label for the DEVICE bank that is active when the labeling is performed.