Rotel RR-1090 owner manual Learning Commands, Macro Programming

English 11

4.Select SEARCH by pressing the MENU COM- MAND key below that label. The prompt “press POWER key to test” appears in the display.

5.Press the POWER button on the right side of the RR-1090 to test the first available code. The 4- digit code being tested is shown in the display.

If the POWER command turns on or off the desired component, you have found a code that may work your component. You can test additional commands by pressing MENU COMMAND keys corresponding to commands for that 4-digit code shown in the display. If successful, press the DEVICE button to save the code.

If the POWER command does not work, press the POWER button to test the next available code, again with the 4-digit code being tested shown in the display. Continue pressing the POWER button and testing codes until you have found a code that works, saving it by pressing the DEVICE button.

If none of the available codes work, a prompt will tell you that you have tested all available codes. Press the MENU button to return to the main menu.

Learning Commands

If the programmed command sets for your compo- nent do not include functions you need, you can teach the RR-1090 individual commands from your exist- ing remotes:

1.Place the RR-1090 and the original remote con- trol on a flat surface end to end as shown in Figure 2 at the front of this manual. The IR signals sent by the other remote must be aimed at the IR emit- ter/sensor of the RR-1090.

2.Press the MENU button to reach the main menu.

3.Select LEARNING from the LCD display menu by pressing the MENU COMMAND key above the first letter of the LEARNING label.

4.Press one of the DEVICE buttons to select where you wish to program this component’s codes.

5.Select the RR-1090 COMMAND key where you wish to memorize the command. You can choose one of the BASIC COMMAND buttons or one of the MENU COMMAND keys (using the PAGE

button to advance to a new page of MENU COMMANDS if necessary to find an unused key). The LCD display will show “LEARNING”.

6.Press and hold the corresponding command but- ton on the original remote to send the IR code being learned to the RR-1090.

If the learning procedure fails, the RR-1090 will display “ERROR” and revert back to Step 5 above. Reposition the two remotes and try again, starting from Step 5.

When a code is successfully learned, the RR-1090 will prompt you to edit the label it has as- signed to the command. Select NO to keep the current label. Select YES to edit the label and enter the desired letters (using the M3 or M4 buttons to move to the next page of letters). Labels can be up to 5 charac- ters. Press the MENU button to store the new label.

To learn additional commands, repeat from Step 5 above. To return to the main menu, press the MENU button.

NOTE: The RR-1090 has a capacity of 240 com- mands. If capacity is reached, the remote will dis- play COMMAND FULL and not allow you to learn an additional command. See the section on delet- ing commands to clear command space.

Macro Programming

Four buttons on the RR-1090 (labeled M1, M2, M3, M4) can store macro sequences of multiple commands sent by pressing one button.

To program a macro sequence, first make sure that all of the desired commands have been learned by the RR-1090 – the macro feature simply records a sequence of individual RR-1090 button commands.

1.Press the MENU button to reach the main menu.

2.Press the PAGE button for the next page of menu options.

3.Select MACRO from the LCD display.

4.Press the MACRO button (M1, M2, M3, or M4) where you wish to store the new macro sequence.