Rotel RR-1090 owner manual Auto-arrange Command Names, Backlighting, Beep Sound, Password

Auto-arrange COMMAND Names

As an alternative to manually moving keys, you can have the RR-1090 automatically arrange the MENU COMMAND keys for a DEVICE.

1.Press the DEVICE button containing the COM- MAND keys you wish to auto-arrange.

2.Press the MENU button to reach the main menu.

3.Select EDIT from the LCD display.

4.Select AUTO-ARRANGE from the LCD display.

Other Configuration Options

The RR-1090 features backlighting and a keytone beep to assist in operation. Additionally, password protection can be enabled to protect access to the setup features.

Backlighting

Backlighting makes the LCD display visible in low light conditions. There are three available settings:

•With Light Sense. Senses the lighting level in the room and turns on the backlighting for 5 seconds with any key press when the room is dark. (default setting)

•Always On. Backlighting will be turned on for 5 seconds with any key press regardless of the room lighting.

•Always Off. Backlighting is disabled.

To configure the backlighting:

1.Press the MENU button to reach the main menu.

2.Press the PAGE button to advance to the second page of menu options.

3.Select REMOTE SETTINGS from the LCD display.

4.Select BACKLIT from the LCD display.

5.Select one of three backlighting modes from the LCD display.

English 15

Beep Sound

The RR-1090 has a keytone feature that beeps to confirm each button press. This feature can be en- abled (default) or disabled.

To configure the beep sound:

1.Press the MENU button to reach the main menu.

2.Press the PAGE button to advance to the second page of menu options.

3.Select REMOTE SETTINGS from the LCD display.

4.Select BEEP SOUND from the LCD display.

5.Select SOUND ENABLE or SOUND DISABLE.

Password

A password can be defined and enabled to prevent access to the setup menus. Once defined and en- abled, the password will be required before access to the setup menus is allowed.

The factory default password is “2000”, however the password protection is disabled by default.

To enable or disable password protection:

1.Press the MENU button to reach the main menu.

2.Press the PAGE button to advance to the second page of menu options.

3.Select REMOTE SETTINGS from the LCD display.

4.Select PASSWORD from the LCD display.

5.Select ENABLE or DISABLE.

6.If prompted, enter the password by pressing the MENU COMMAND keys corresponding to the characters shown in the display (using the M3 or M4 buttons to move to the next page of char- acters). After entering the password, press the MENU button.

To change the password:

1.Press the MENU button to reach the main menu.

2.Press the PAGE button to advance to the second page of menu options.

3.Select REMOTE SETTINGS from the LCD display.

4.Select PASSWORD from the LCD display.