Rotel RHB-200 manual Learning invisible layer commands

14RKP-200/RHB-200

5.Aim the handheld remote at the oval sensor on the front of the keypad from a distance of approxi- mately 1 inch (25 mm). Press and hold the button on the handheld remote with the command to be learned (the PAUSE button, in this example).

6.If the command is successfully learned, the button will flash twice. Six flashes indicate that the learning failed. If the learning failed, repeat from Step 4.

7.To learn additional commands, repeat from Step 4, pressing the next keypad button to be learned.

8.Exit Learning mode by setting SW7 to the OFF position:

Learning invisible layer commands

Each of the four devices (, , , ) on the RKP-200 keypad can store 14 invisible layer com- mands. These commands cannot be accessed dur- ing normal operation of the keypads; however, they can be used as part of Smart Macro sequences.

The procedure for learning an invisible layer com- mand is similar to learning a standard command, except that four switches SW1 – SW4 are used to select the invisible layer, one switch correspond- ing to each device. Once the invisible layer is se- lected, any of the 14 buttons can be used to store an invisible layer command without overwriting the standard commands stored for each button. With an invisible layer for each of the four devic- es, a total of 56 invisible layers commands can be stored, 14 for each device

To learn an invisible layer command:

1.The button lighting flashes to confirm suc- cessful or failed learning. So, the backlighting feature must be active before starting the learn- ing procedure (SW10 in the ON position). Also, the IR sensor must be enabled (SW9 in the ON position). Confirm the position of SW9 and SW10:

2.Select the device where you want to store the invisible layer command by placing one (and only one) of switches SW1 – SW4 in the ON position, as follows.

To learn invisible layer commands for the CD device, place SW1 in the ON position:

To learn invisible layer commands for the TUN device, place SW2 in the ON position:

To learn invisible layer commands for the AV device, place SW3 in the ON position:

To learn invisible layer commands for the MP3 device, place SW4 in the ON position:

To learn standard commands, exit the invisible layer mode by putting SW1 – SW4 all in the OFF positions. :

3.Put the keypad into Learning mode by moving SW7 to the ON position. In this example, we are learning invisible layer commands for the CD device: