Overburn
The default setting for this feature is OFF. Overburn can be used with certain CD recorders, to allow more data to be writing to the disc. This feature is not supported by the
Read Error Skip
The Read Error Skip feature is used if you wish to ignore read errors during duplication. The default setting is OFF and it is highly recommended that this setting is not changed. If it is turned ON, there is the possibility of copying a disc that is not the same as the master.
Burn-in
The
Update Firmware
The Update Firmware feature is used to update the controller firmware.
1.To update the firmware: Place the firmware CD into the TOP reader drive.
2.Press the ENT button
3.The display will show:
Update F/W | A.ABC |
To A.XYZ | YES? |
|
|
4.Press the ENT button to complete the firmware update.
5.The duplicator will reboot automatically after installing the new firmware.
Compare Firmware
The Compare Firmware function is used to compare the firmware installed on the controller with the firmware on the CD.
H/W Diagnostic
Hardware Diagnostics runs a number of tests on the controller. Normally this function is used by service personnel.
Load Default
The Load Default feature will set all the values back to the factory default settings.
ISRC & MCN
The ISRC (International Standard Recording Code) & MCN (Media Catalog Number) feature allows you to copy this information from a CD audio master to the blank disc. The default setting if OFF.
Switch USB Mode
The Switch USB Mode allows you to enable or disable the ability to use the
The
18