JVC LPT1056-001A manual Troubleshooting, Symptom Cause Correction

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.

Symptom		Cause		Correction
No power.	•	The power cord is disconnected.	•	Plug the power cord into the wall outlet
				securely.
The power is on, but the	•	DVD or VCR button is not switched	•	Refer to page 5.
DVD+VCR does not		properly.
work.
	•	No disc is inserted.	•	Insert a disc or tape. (Check that the
	•	No tape is inserted.		disc or tape indicator in the display
				window is lit.)
No picture.	•	The TV is not set to receive DVD+VCR	•	Select the appropriate video input
		signal output.		mode on the TV so the picture from the
				DVD+VCR player appears on the TV
				screen.
	•	The video cable is not connected securely.	•	Connect the video cable into the jacks
				securely.
	•	Mismatch setting between TV and this	•	Select the correct Video Output in
		unit.		SETUP menu.
	•	Wrong connection.	•	Check the connection.
No sound.	•	The equipment connected with the audio	•	Select the correct input mode of the
		cable is not set to receive DVD+VCR		audio receiver so you can listen to the
		signal output.		sound from the DVD+VCR.
	•	The audio cables are not connected	•	Connect the audio cable into the jacks
		securely.		securely.
	•	The power of the equipment connected	•	Turn on the equipment connected with
		with the audio cable is turned off.		the audio cable.
	•	The AUDIO options are set to the wrong	•	Set the AUDIO options to the correct
		position.		position.
The playback picture is	•	The disc is dirty.	•	Clean the disc.
poor.
	•	The TV channels are not tuned in	•	Check tuning, carry out tuning again.
		properly.
	•	Tape heads are dirty.	•	Clean video heads.
	•	Tape is a rental or was recorded on	•	Use PR/TRK (3/4) for manual
		another VCR.		tracking adjustment while tape is
				playing.

REFERENCE

37