JVC LPT1056-001A manual Dvd+Vcr

Troubleshooting (Continued)

Symptom		Cause		Correction
The DVD+VCR does not	•	An unplayable disc is inserted.	•	Insert a playable disc. (Check the disc
start playback.				type and Regional code.)
	•	The disc is placed upside down.	•	Place the disc with the playback side
				down.
	•	The disc is not placed within the guide.	• Place the disc on the disc tray correctly
				inside the guide.
	• The disc is dirty.		•	Clean the disc.
	•	The Rating level is set.	•	Cancel the Rating function or change
				the rating level.
Video tape cannot be	•	Is the cassette compartment empty?	•	Eject the tape in.
inserted.
No Hi-Fi sound	•	Audio mode is not set properly.	• Select STEREO by repeatedly pressing
				AUDIO on the remote control.
No NICAM sound	•	NICAM mode is not set properly.	• Make sure NICAM in the menu is set to
recording				AUTO for the station to be recorded.
The remote control does	•	There is an obstacle in the path of the	•	Remove the obstacle.
not work properly.		remote control and this unit.
	•	The batteries in the remote control are	•	Replace the batteries with new ones.
		exhausted.
	•	The remote control is not pointed at the	•	Point the remote control at the remote
		remote sensor of the DVD+VCR.		sensor of the DVD+VCR.
	•	The remote control is too far from the	•	Operate the remote control within 23ft
		DVD+VCR.		(7 m).
	•	This remote control use the same buttons	• When using a VCR, first press the VCR
		for VCR and DVD functions (ex.PLAY).		button. When using a DVD, first press
				the DVD button.
Timer recording is not	•	Clock in DVD+VCR is not set to correct	•	Set clock to correct time.
possible.		time.
	•	Timer has been programmed incorrectly.	•	Reprogram Timer.
	•	indicator light does not appear after	•	Reprogram Timer and turn DVD+VCR
		programming timer.		off to enable timer.

38