Magnavox ZV427MG9 A owner manual Press OPEN/CLOSE a, Repairing process MAY not work, Rec

TROUBLESHOOTING

DVD

Symptom			Remedy
The disc tray does not open when you			• It may take a few seconds for the disc tray to open after you have
press [OPEN/CLOSE A].			recorded or edited a disc. This is because the unit is adding disc data to
			the disc.
“Repairing” appears on the TV screen.			• If there is a power failure or unplugging during recording, finalizing,
			formatting or editing (even after “Repairing” disappears), a repairing
			process will begin automatically just after turning the unit on again.
	Repairing
			It may take several minutes up to about several hours.
In a case you intend to cancel the			• If you intend to cancel the repairing process, press [AOPEN/CLOSE]
repairing process.			on the front panel, then select “Yes” and press [OK]. After that, press
			[OPEN/CLOSE A] to take out the disc. The disc canceled during the
		Do you want to cancel a repairing	repairing process MAY NOT work.
		process? When selecting “Yes”,
		the disc may not be usable.
		Yes
		No
	Repairing

VCR

Picture noise appears.	• Head cleaning for VCR may be necessary. Refer to “Auto head cleaning”
	(page 4).
	• Adjust tracking control for better picture by pressing [TRACKING / ]
	while you are playing back a cassette tape.
The cassette tape does not play back.	• No cassette tape is inserted.
Recording does not start after you press	• Make sure the cassette tape has an erase-protection tab when you
[REC].	record to a cassette tape. If needed, cover the hole with cellophane
	tape.
The remote control does not function.	• Check if a cassette tape is in this unit.
The motor rotates even when	• The motor may rotate for the duration of approximately 5 minutes for
playback / recording is stopped.	efficient operation. This is not a malfunction.

88 EN