Tuning, Setup, Auto Channel Programming

TUNING

This DVD+VCR is equipped with a frequency synthesized tuner capable of receiving up to 181 channels. These include VHF channels 2-13, UHF channels 14-69 and CATV channels 1-125.

Auto Channel Programming

1.Choose the SOURCE SELECT option, then use b / B to select TUNER.

Use b / B to switch among TUNER, LINE1, and LINE2.

2.Choose the AUTO CHANNEL SET option, then use b / B to find channels.

•The tuner will automatically cycle through all available channels (TV/CATV) in the area and place them in the tuner’s memory.

•After the AUTO CHANNEL SET is complete, the TUNING menu will hide and return to the TV screen automatically.

•If the power fails or the DVD+VCR is unplugged the channel settings are kept in memory for only 3 seconds.

3.Make sure the TUNING BAND is set appropri- ately (TV or CATV).

•TV : If you are using a standard antenna to receive channels.

•CATV : If you are using basic cable to receive channels.

To Add or Erase Channels

This feature allows you to add or erase channels from memory manually.

1.Choose the CH. ADD/DEL option, then use b / B to select a channel to add or erase.

2.Use ENTER / OK to add or erase the channel. Repeat steps 1 and 2 to add or erase other channels.

3.Press SETUP MENU to return to the TV screen.

SETUP

FUNCTION OSD

The on-screen display can be turned on or off.

AUDIO MODE

The DVD+VCR has two separate audio playback systems, the high quality VHS Hi-Fi system and standard NORMAL mono system. The same audio is generally recorded on both systems. The VHS Hi-Fi system plays on separate (left and right) channels, and the NORMAL system plays monaural sound. The normal track is always played so the cassette can be played on a DVD+VCR that does not have VHS Hi-Fi.

BROADCAST TYPE (STEREO / SAP / MONO)

Multichannel Television Sound (MTS) carries stereo and/or Second Audio Program (SAP) bilin- gual signals. Set this display to the desired posi- tion when both MTS stereo and SAP signals are received. When only one of the MTS signal is received, the DVD+VCR automatically selects the corresponding receiving mode (Stereo or SAP) regardless of the selected position. For normal operation, the display should be in the STEREO position. The DVD+VCR will then record a STEREO program when available, and record a mono program IF the program is NOT IN STEREO. For weak STEREO and/or SAP broad- casts, changing the display to mono may give clearer sound.

AUDIO OUTPUT (STEREO / LEFT / RIGHT)

Used during playback [when AUDIO MODE (HI-FI/ NORMAL) is in HI-FI position] for selecting the audio output signals from the AUDIO OUT termi- nals (L ch and R ch), and RF.OUT. This display setting should normally be left in the stereo posi- tion, so that when a stereo tape is played, the stereo sound will be heard through the left and right channels. If a mono tape is played and the audio output is set to stereo, the same mono sound will be heard from both left and right channels.

In addition to the above settings, these other sources are also affected:

1.Playback of CD, DVD or VCD

2.Output of built in tuner, Line 1 or Line 2

JVC HR-XVC18BUS, HR-XVC19SUS Tuning, Setup, Auto Channel Programming, To Add or Erase Channels