LG Electronics XBR446 Reset the VCR/DVD Recorder, If you observe any of the following symptoms

Troubleshooting (Continued)

Symptom	Cause	Solution
Cannot record or did not	The remaining blank space on the disc is	Use another disc.
record successfully.	insufficient.
	The source you are trying to record is copy-	You cannot record the source.
	protected.
	When setting the recording channel, the	Select the channel on the VCR/DVD
	channel is tuned on the TV’s own tuner.	Recorder’s built-in TV tuner.
	When recording to a Video mode disc, pro-	Use a VR mode formatted disc for copy-once
	grams that are copy-once protected cannot	material.
	be recorded.
Timer Recording not possi-	Clock in VCR/DVD Recorder is not set to	Set clock to correct time. See “Auto Clock
ble.	correct time.	Set” or “Manual Clock Set” on page 21.
	Timer has been programmed	Reprogram Timer. See “Timer Recording” on
	incorrectly.	page 46.
	TIMER indicator light does not appear after	Reprogram Timer.
	programming timer.
Stereo Audio Record	TV is not Stereo-compatible.	No solution.
and/or Playback not pres-
	Broadcast program is not in stereo format.	No solution.
ent.
	VCR/DVD Recorder A/V Out jacks are not	Make A/V connections. Stereo is available
	connected to TV A/V In jacks.	only via A/V output from VCR/DVD Recorder.
	VCR/DVD Recorder Audio/Video Out is not	Select AUX or A/V source as TV input.
	selected for viewing at the TV.
	VCR/DVD Recorder’s TV audio channel is	Set TV audio channel mode to Stereo. See
	set to SAP or MONO.	“Changing TV Audio Channel” on page 29.
Remote control does not	The Remote Control is not pointed at the	Point the Remote Control at the remote sen-
work properly.	remote sensor of the VCR/DVD Recorder.	sor of the VCR/DVD Recorder.
	The Remote Control is too far from the	Operate the Remote Control
	VCR/DVD Recorder.	within 23 ft (7 m).
	There is an obstacle in the path of the	Remove the obstacle.
	Remote Control and the VCR/DVD Recorder.
	The batteries in the Remote Control are	Replace the batteries with new ones.
	weak or dead.

Reset the VCR/DVD Recorder

If you observe any of the following symptoms...

When the VCR/DVD Recorder is plugged in, but the power will not turn on or off.

When the display window does not working.

When the VCR/DVD Recorder does not operate normally.

You can reset the VCR/DVD Recorder as follows :

Press and hold the POWER button for more than five seconds. This will force the VCR/DVD Recorder to power off. . Press the POWER button again to turn the VCR/DVD Recorder back on.

Unplug the power cord and then plug the power cord again after more than five seconds.

64