Daewoo SH-9810P, SH-3510P, SH-9840P instruction manual Connections and Copying

Connections and Copying

■If you are using a SCART cable, select the AV input on the TV to see the picture from the player.

■If you are not using a SCART cable, select the programme number on the TV reserved for video input to see the picture from the player.

To the TV via antenna cable (if you are not using a SCART cable)

If you are not using a SCART cable, your player can transmit pictures and sound to the TV via the coax aerial cable. Just tune the TV to the player's transmitting channel (factory set to UHF CH 52). Tune the TV carefully to ensure the best pictures and sound.

1	Once you have carried out the steps in "Connecting up the player" , switch
	on your TV.
	Press the [ENTER] button of the player’s remote control for longer than 5
	seconds to call up the player´s test signal.
	Tune the TV to the test signal using the channel pre-set functions of your
	TV as described in its manual.
	When you have found the test signal, store it under the channel number
	on your TV for player input.
	Press the [ENTER] button of the player’s remote control again for longer
	than 5 seconds to remove the test signal.
2	• If the quality of the test signal transmitted to the TV is poor due to
	interference caused by a station transmitting on channel 52, you can tune
	the player to a different transmitting channel. Find a free channel

between 21 and 69 on your TV.

Call up the player’s "SETUP" menu, choose "VCR SETUP" then "RF

OUTPUT SET".

Type in the free channel.

Store and exit.

RF OUTPUT SET

CH52

0-9:SELECT (21-69)

OK:CONFIRM SETUP:END

VCR Operation

•If the quality of the test signal transmitted to the TV is poor, fine-tuning on the TV may help (refer to the TV manual).

•Without a scart cable, you will not get stereo sound from a TV capable of stereo sound.

33