GoVideo DV1130Q Connections Basic TV Connections, RF coaxial connection, Audio/Video connection

Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on the capabilities of your existing equipment.

RF coaxial connection

Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on your TV using the supplied 75-ohm coaxial cable (R).

ote

If you use this connection, tune the TV to the DVD+VCR’s RF output channel (CH 3 or 4).

How to set the DVD+VCR’s RF output channel

1.While the DVD+VCR is turned off, press and hold CH (v/V) on the front panel for about five seconds.

The unit will turn itself on and “RF 03” or “RF 04” appears on the front panel display.

2.Use CH (v/V) on the front panel or CH (v/V) on the remote control to change the RF output

channel (CH 03 or CH 04).

3.Turn the DVD+VCR off and then on.

4.Set the TV to channel 3 or 4 depending on the RF output channel you selected.

Now you can watch the DVD+VCR playback on CH3 or CH4 of your TV.

Audio/Video connection

1DVD+VCR to the video in jack on your TV using the supplied video cable (V).Connect the DVD/VCR VIDEO OUT jack on the

2 Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on your TV (A1) using the supplied audio cables.

ote

If you use this connection, set the TV’s source selector to VIDEO (sometimes referred to as Line, Aux, Input, etc.).

TV Connections Panel

ANTENNA	AUDIO INPUT		VIDEO
INPUT			INPUT
	L	R

R A1 V

DVD+VCR Connections Panel

12