Emerson EWR20V5 owner manual VCR/DVD recorder Switching

Page 12

Before you start

Functional overview (cont’d)

Installing batteries in the remote control Using a remote control

Install two “AA” size batteries (supplied), matching their polarity to those indicated inside battery com- partment of the remote control.

1

2

3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please follow the instruction below:

• Do not mix new and old batteries together.

• Do not use different kinds of batteries together.

Although they may look similar, different batteries

may have different voltages.

• Make sure that the plus and minus ends of each

battery match the indications in the battery com-

partment.

• Remove batteries from equipment that is not going

to be used for a month or more.

• When disposing used batteries, please comply with

governmental regulations or public rules for envi-

ronmental protection that apply in your country

or area.

• Do not recharge, short-circuit, heat, burn or disas-

semble batteries.

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor of the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is on the remote sensor of the unit.

•Remote control for different devices can inter- fere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall-off of the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Beeline: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23feet (7m)

30˚

The VCR/DVD recorder Switching

Remote control

30˚

Because this product is a combination of a VCR and a DVD recorder, you must select first which com- ponent you wish to operate with [SELECT].

VCR MODE

Hit [VCR] on the remote control. (Verify that the VCR indicator is lit.)

DVD MODE

Hit [DVD] on the remote control. (Verify that the DVD indicator is lit.)

Notes:

•Hitting only [SELECT] on the front panel DOES NOT switch the mode of the remote control.You MUST select the correct mode on the remote control.

•You cannot switch to another mode (DVD or VCR) during in the timer-standby mode.

•Pressing [REC/OTR] (DVD) or [REC/OTR] (VCR) on the remote control switches immedi- ately its respective mode so that you can start recording directly on the appropriate media.

SELECT button

VCR button

DVD button

VCR SELECT DVD

DVD indicator

VCR indicator

POWER

T-SET

 

OPEN/CLOSE

 

TIMER PROG.

.@/:

ABC

DEF

 

1

2

3

 

GHI

JKL

MNO

CH

4

5

6

 

PQRS

TUV

WXYZ

VIDEO/TV

7

8

9

 

DISPLAY

SPACE

CLEAR

SETUP

 

0

 

 

TOP MENU

MENU/LIST

RETURN

ENTER

REC/OTR

VCR

DVD

REC/OTR

REC SPEED

 

PLAY

 

REC MONITOR

SKIP

PAUSE

SKIP

SLOW

CM SKIP

STOP

SEARCH

DUBBING

ZOOM

AUDIO

 

10

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Hit Setup Example of a TV Example of a TV remote controlSelect any blank line and hit Enter EndAfter all recordings, finalize your disc Hints for DVD RecordingSupplied Accessory Changing the Setting menu VCR functions Others EspañolEditing Precautions Laser SafetyBefore you start Model No Serial NoPrecautions cont’d Before youInstallation Location Reverse engineering or disassembly is prohibitedMaintenance Dolby Digital RecordingTable of contents Features RecordingEditing CompatibilityFunctional overview 12 11Functional overview cont’d VCR/DVD recorder Switching Setting/DISC/CD menu Display menu First DVDFirst VCR Hit Display to display the onscreen displayDisplay message Status of the unitTitle/Track and Chapter MarkPlug in the AC power ConnectionsConnection to a TV MethodConnection to a cable box or satellite box After you have completed connectionsTo select channels of the cable box or satellite box Connection to an Audio System Method Stereo system Analog audio Input jacksMethod Dolby Digital decoder MD deck or DAT deck Digital audioGetting started Easy DVD recordingThis operation may take a while to be recognized Connections Getting started Recording DiscEasy DVD recording Cont’d Speed ChannelChannel setting Getting channels automaticallyChannel setting cont’d Adding/deleting channelsUsing K / L, select Advanced Setting Menu. Hit Enter Using K / L, select TV Audio Select. Hit EnterUsing K / L, select Stereo or SAP. Hit Enter Selecting the TV stereo or SAPSetting the clock Auto Clock SettingSetting the clock cont’d Manual Clock SettingSetting the daylight saving time Selecting the TV aspect ratioRecording Information on DVD recordingInformation Recordable discWhat is CPRM? Information on DVD recording cont’dRestrictions on recording Making discs playable on other DVD player FinalizeFormatting a disc Choosing the recording format of a blank discReformatting a disc Basic recording Checking the recording picture and sound qualityOne-touch Timer Recording When a DVD-RW disc is loadedUsing REC/OTR and Stop C First DVD Turn on the unit and load a recordable discTimer Recording StartTimer Recording cont’d Hints for Timer Recording Priority of overlapped settingsBefore you start Connections Getting started Recording Disc Settings for an external source Connection to an external sourceIf you want to use Video input Composite Settings for an external source cont’d Setting a disc to protectRecording from an external source Using K / L, select Finalize. Hit Enter Finalizing the discsFinalizing will start Using K / L, select Auto Finalize. Hit Enter Using K / L, select on Hit EnterFinalizing the discs cont’d Auto finalizeDubbing Mode Using K / L, select Dubbing Mode. Hit EnterMake sure Insert a recordable disc and a videotape with a record tabDubbing Mode cont’d Using K / L, select VCR DVD. Hit EnterHit Setup to exit Hit DVD Using K / L, select DVD VCR. Hit EnterDisc Playback Information on DVD playbackBasic playback PlaybackBasic playback cont’d Playing back MP3 discHit Play B to start play- back Hints for MP3 filesPlaying back discs using the disc menu Playing back discs using the title menuSpecial playback Resume playbackFast forward / Fast reverse Skipping TV commercials during playbackSpecial playback cont’d PauseStep by step playback Slow forward / Slow reverse playbackMarker Setup Using / B, select icon. Hit EnterZoom During playback, hit ZoomUsing Skip H/ G Using DisplaySearch Title/Chapter searchSearch cont’d Track searchTime search Repeat playback Random playbackSwitching subtitles Repeat/Random/Program playback cont’dSelecting a format of audio and video Program playbackSwitching audio soundtrack Using K / L, select a desired audio channel. Hit EnterSelecting a format of audio and video cont’d During playback, hit AudioSwitching camera angles Some DVD-Video discs feature Scenes shot from two or moreVisual Noise Reduction Noise Reduction menu will appearEditing Information on disc editingEditing discs in Video mode Deleting titlesPutting names on titles Editing discs in Video mode cont’d Setting or clearing chapter markersFirst DVD Using K / L, select Yes Hit Enter Using K / L, select Chapter Mark. Hit EnterEditing discs in VR mode Original Using K / L, select Original. Hit EnterBe advised that the titles once deleted cannot be recovered Original list will appearEditing discs in VR mode Original cont’d Setting titles to protectUsing K / L, select Protect. Hit Enter Follow steps 1 to 3 on page 57 to display the Original menuYou can cancel the title-protecting Releasing titles from protectingConfirm the indication On OFF. Hit Enter Key icon will disappear from the title in the original listEditing discs in VR mode Playlist First DVD Hit SETUP. Using / B, select Disc. Hit EnterUsing K / L, select Playlist. Hit Enter Deleting parts of titles Editing discs in VR mode Playlist cont’d Using K / L, select Edit Title Name. Hit EnterWhen you select Add at , a DeleteYou cannot delete the first chapter of each title New chapter marker will be addedSetting pictures for thumbnails Picture for thumbnail will be setUsing K / L, select Yes. Hit Enter Dividing a titleYou can divide a title into two New titles After this operation is comUsing K / L, select Title Combining. Hit Enter Combining titlesYou can combine two titles into a single title Two titles will be combined into a single titleAdding titles to a Playlist Deleting a PlaylistChanging the Setting menu Tour of the Setting menuLanguage setting Language setting cont’d Display settingSubtitle Language Default OFF Using K / L, select a lan Guage. Hit EnterDisplay setting cont’d Audio settingAudio setting cont’d Using K / L, select a set- ting. Hit EnterUsing K / L, select a setting. Hit Enter When playing back a DVD-RW disc recorded in VR modeSettings for Parental lock level Hit Stop C if you are playing a discSettings for Parental lock level cont’d Parental Lock Default AllUsing K / L, change the parental level. Hit Enter If you select No, proceed to stepRecording and One-touch Timer Recording VCR functionsPlayback RecordingRecording and One-touch Timer Recording cont’d One-touch Timer RecordingUsing REC/OTR or Stop C Index searchOther operations Troubleshooting Symptom RemedyOthers Or Setup Troubleshooting cont’d SymptomCause Solution RF output switch Error message Cause SolutionFor more than 3 seconds Before you start Connections Getting startedGlossary Language codeFrequently Asked Questions SpecificationsCan I record on CD-R/RW? No, this unit records only DVDs Español Fácil grabación de DVDNota Esta operación puede demorar en reconocersePaso 6 Pare la GrabaciónReproducción con videograbadora NotaGrabación Grabación con temporizador de un toque OTRLimited Warranty
Top Page Image Contents