Overview (Continued)
Recording TV audio channels
This recorder can record either NICAM or regular audio. If the NICAM setting (page 22) is set to Auto, then if the broadcast is NICAM, you can record the NICAM audio. If the broadcast is
Restrictions on video recording
•You cannot record
•NTSC format signals from the analog or the DV inputs is not recorded correctly with this recorder.
•Video signals in SECAM format (from the
Copyright
•Recording equipment should be used only for lawful copying and you are advised to check carefully what is lawful copying in the country in which you are mak- ing a copy. Copying of copyright material such as films or music is unlawful unless permitted by a legal exception or consented to by the rights owner.
•This product incorporates copyright protection tech- nology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision cor- poration. Reverse engineering or disassembly is pro- hibited.
•CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COM- PATIBLE WITH THIS PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF 625 PROGRESSIVE SCAN PICTURE PROBLEMS, IT IS RECOMMENDED THAT THE USER SWITCH THE CONNECTION TO THE ‘STANDARD DEFINITION’ OUTPUT. IF THERE ARE QUESTIONS REGARDING OUR TV SET COMPATI- BILITY WITH THIS MODEL 625p RECORDER, PLEASE CONTACT OUR CUSTOMER SERVICE CENTER.
Remote Control Operation Range
Point the remote control at the remote sensor and press the buttons.
Remote Control Battery Installation
Detach the battery cover on the rear of the remote control, and insert two (size AA) batteries with 
and 
aligned correctly.
Caution
Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).
Reset the Recorder
If you observe any of the following symptoms...
The front panel display is not working.
The Recorder is not operating normally.
...you can reset the Recorder as follows:
Press and hold the
Unplug the power cord, wait at least five seconds, and then plug it in again.
10