LG Electronics LT64 owner manual Mounting on a table, Image shown may differ from your TV

		ASSEMBLING AND PREPARING 11
Mounting on a table
		Securing the TV to a table
1 Lift and tilt the TV into its upright position on a	(Only 32/37/42/47LT64**)
table.	Fix the TV to a table to prevent from tilting forward,
	damage, and potential injury.
- Leave a 10 cm (minimum) space from the
	Mount the TV on a table, and then insert and
wall for proper ventilation.
	tighten the supplied screw on the rear of the stand.

	10 cm
10 cm	10	cm
	10 cm

ENGLISH

2Connect the power cord to a wall outlet.

CAUTION

yyDo not place the TV near or on sources

of heat, as this may result in fire or other

damage.

Attaching the TV to a table

Image shown may differ from your TV.

The TV must be attached to desk so it cannot be pulled in a forward/backward direction, potentially causing injury or damaging the product.

(Only 32/37/42/47LT64**)

4-Screws

(not provided as parts of the product) Stand

Table

Screws: M4 x L (*L: Table depth + 8-10 mm)

ex) Table depth: 15mm, Screw: M4 x 20

WARNING

yyTo prevent TV from falling over, the TV should be securely attached to the floor/ wall per installation instructions. Tipping, shaking, or rocking the TV may cause injury.

Adjusting the angle of the TV to suit view

Swivel 90 degrees to the left or right and adjust the angle of the TV to suit your view.

90 90

CAUTION

yyWhen adjusting the angle of the product,

watch out for your fingers.

»» Personal injury may occur if hands or fingers are pinched. If the product is tilted too much, it may fall, causing damage or injury.